Search results

  1. R

    1972 25hp evinrude water over flow issue

    That cylinder head is likely warped , they all are.-----Unless it was refinished already.
  2. R

    1972 25hp evinrude water over flow issue

    Looks like the core plug , bottom of cylinder head is leaking.----Easy fix.
  3. R

    1979 25 HP Evinrude

    I would say if spark can jump a gap of 3/8" or more then stator is good.---If you lay a sparkplug on the block and see spark , that does not mean stator is good.
  4. R

    1987 Johnson VRO70 Model # J70TLCUR

    The VRO can be tested ----Or mix at 50: 1 in your tank.----Mark oil tank level.----Run the fuel tank empty and see how much oil is needed to bring oil level up to your mark.----And does the hose for the tell tale come off the side off the engine block or off the top??----Install a new water pump...
  5. R

    2006 115ELPT4S running rough at low speed, fine at high speeds

    Check availability of a new high pressure pump.-----Or perhaps have dealer check fuel pump output pressure.----Check lift pump as well.
  6. R

    1981 70 Johnson. How to manually raise motor...

    That is not TRIM.----Just electric tilt for docking , slow speed running.----There should be a release valve under the motor / pump assembly.----Lucky you if you can turn it to release and raise the motor?
  7. R

    1972 25hp evinrude water over flow issue

    What rubber hose / plastic fitting on this model ?----There was no tell tale on this 72 model when it left the factory.
  8. R

    Green people destroyed another fantastic fishing area.

    Seems when farmers put manure out on the fields we end up with good barley and tasty beer.----Pigs wallow in the mud and we end up with tasty bacon.-----Nature is really spectacular sometimes.
  9. R

    Force 120hp won't start

    It should fire right up with fuel in the cylinders.-----Checked the flywheel key ?---Torqued flywheel nut to the correct value ?----I would say you need to do some more trouble shooting.----Something really simple is the issue.----Just my opinion as I can not see or touch this motor.
  10. R

    Force 120hp won't start

    Is the choke solenoid working and adjusted properly?----Are you advancing throttle in neutral . YA of NEE ?----Are you engaging choke while cranking it over to start?-----Or do this test.----Remove sparkplugs.----Put 6 drops of fuel in each plug hole.----Install the plugs.---Crank it over and...
  11. R

    What do these knobs do?

    I have 2 of those 50 V-4 quietly resting in the shed.
  12. R

    1994 112 johnson special, blown cylinder? What now?

    These are a great smooth running simple motor.----Easy to maintain and repair.-----Do not need $150 / hr dealer support.
  13. R

    1972 25hp evinrude water over flow issue

    Likely the core plug item #15 is leaking or missing.----
  14. R

    What do these knobs do?

    Never mind the outboard.----How much for that 59 /60 Chevrolet?
  15. R

    1972 25hp evinrude water over flow issue

    There should be no water there at all.----Find the leak.---Repair the leak.
  16. R

    Alarm sounding at higher RPM in neutral

    There would be lots of exhaust bubbles in the water.----Water pump does not pump air.----You have installed a new impeller since you got this boat ?
  17. R

    Sea Ray 1977 200SR

    Sounds like it is an electric shift OMC.-----Do a complete evaluation on this boat / engine / drive BEFORE spending any hard earned coins on it !!
  18. R

    1989 Force 50 won’t idle after engine warms up

    Open slow speed mixture screw 1/8th turn at a time and test run.
  19. R

    Won’t stay running 125 force pestoline

    Post actual results of a compression test.
  20. R

    Evinrude 30 hp compression question

    You have a worn out motor or compression tester that is poor quality.---Simple as that.
Top