Search results

  1. R

    Water tube

    ???-----There is a simple grommet halfway up the exhaust housing.----You slide the water tube out.----Cut off 5 "-----Slide the water tube back in.-----Elegantly simple.
  2. R

    Water tube

    On this 1975 model 25 HP it is a simple 10 minute job to shorten / re-instal the water tube.----Powerhead does not have to come off !!!
  3. R

    Went electric

    I used to go to the local landfill.------Picked up a few repairable gas powered lawnmowers there.-----Have seen a few electric lawnmowers ( 115 volt and battery ) as well.----Funny things is a week later the electric ones are still there.
  4. R

    Evinrude 20 Poor Water Flow

    When the motor left the factory there were 3 rubber pieces installed in the block.-----They guide water around for proper cooling.------Are those 3 pieces installed now ??
  5. R

    Water tube

    Install 3/ 4 packing washers.----Tighten the packing follower to jam the packing on the needle.----Simple in my opinion.
  6. R

    1998 honda 75 hp completely dead

    Check fuses ?
  7. R

    Water tube

    Water tube simply pulls out of the grommet.-----Cut 5" off and re-install
  8. R

    J115PX4STS Bushing on Drive Shaft - What Is It? Why Is It?

    On the extra long shaft Suzuki motor this keeps the driveshaft from whipping around.
  9. R

    Went electric

    Neighbor bought an all electric snowblower.---Only about $2000 or so.----Comes with 3 batteries and the charger.-----I suggested he maybe get a spare battery.-----Looked up the price of the battery.----Found that each battery is about $300 or more.-----No thanks to this electric stuff.
  10. R

    OMC 260 Stringer Stern Drive??

    The last year for electric shift OMC sterndrive was 1977.-----The Hydro-Electric system ( per post #4 ) was never used on OMC sterndrives !!
  11. R

    OMC 260 Stringer Stern Drive??

    Nope-----It is NOT a hydro-electric shift unit !
  12. R

    Mid-80’s Evinrude remote control

    Correct-----Lever can be mounted on the other side.---When box is off the console it takes one screw to swap the lever to the other side.----Box does not need to be taken apart for that simple procedure.------Is the motor running when you shift this control box?----Or is someone turning the prop...
  13. R

    OMC 260 Stringer Stern Drive??

    Not electric shift.
  14. R

    Need advice

    If water birds are diving / feeding on the surface then likely there are bigger fish around.----That is where you throw a line in.-----Nature simply does not need HUMANS with electronics around to do even more damage to dwindling fish stocks.
  15. R

    No start with key

    What motor ?----Checked the fuse?
  16. R

    Need advice

    Most folks go fishing to relax I think.-----No need to involve more complex phones into fishing for me.
  17. R

    Need Help Finding info on OMC 260

    Your location ?----
  18. R

    Wet sanding gel coat

    Use 600 wet dry.----Followed by 1200 or even 2000 wet dry.-----Then polish with any number of paint polish or buffing compounds.
  19. R

    What gives with helping people with a problem ?????????????

    Just think----Rarely do you get a tip after spending hrs repairing an expensive motor.----That same person will tip the pretty waitress / bartender before the pint is in front of them !-----But I used to get a bonus on occasion before starting work on a motor -.----Fish fillet / moose steak /...
  20. R

    Milky fuel in carb intake force 85hp

    Oil / gas mixtures are not well understood .----Most manuals would say 25:1 on a rebuild..------Hopefully you spent some time lining up the connecting rod caps.
Top