Search results

  1. Scott Danforth

    AADULT SECTION WHERE IS IT

    The only legal source for OMC manuals. https://outboardbooks.com/
  2. Scott Danforth

    Ford 302 mechanical fuel pump

    I would have bought this one. https://www.summitracing.com/parts/crt-m60389
  3. Scott Danforth

    I/O (Sterndrive) Conversion to Outboards

    Be leery of signing any paperwork..... pretty sure the admiral is upping your life insurance and watching movies on HLN (Homicidal Ladies Network)
  4. Scott Danforth

    Mercruiser shifter

    that was probably not adjusted correctly there are also videos on adjusting the mercruiser lower shift cable in the stickies
  5. Scott Danforth

    Ideal cylinder head temp range force 50 hp

    Haven't ever had that problem since 2008
  6. Scott Danforth

    Surge Trailer brakes

    My guess adjusted too loose and one of the pistons came out too far and cocked in the bore
  7. Scott Danforth

    New to me used 2.3l

    Boats are expensive I wouldn't flush with diesel Is this motor proven to be a runner? Compression numbers? Change the timing belt
  8. Scott Danforth

    Mercruiser 120 Fuel Help

    Dwell is not .022. that is the rough gap. Dwell is 34 degrees If dwell is off, coil saturation time is off and timing is off. I would tighten your rough gap to .018-0.020 and it will run a bit better. You probably did not file the points, so your rough gap is already different than what...
  9. Scott Danforth

    Mercruiser 120 Fuel Help

    Is you set the points with a dwell meter? Is your timing correct?
  10. Scott Danforth

    I/O (Sterndrive) Conversion to Outboards

    Which naval architect?
  11. Scott Danforth

    projects other than boats

    Back down the shifter rabbit hole. found the aisin transmission factory parts I need to move the shifter forward almost 8" any salvage yard hunters, if you see a MK 2 Toyota Supra (1981-1986) with a junk 5MGE trans and a good shifter, looking for the MA61 shifter assembly. that is the 18"...
  12. Scott Danforth

    How to fix stress crack in fiberglass under seat cushion

    No only way to get the stress cracks to stop is to grind down and build back up
  13. Scott Danforth

    Lowrance 3500 transducer bit the dust after 24 years

    Look at the old transducer and read the airmark number and hope/pray it is still made, or buy new gauge/transducer combo
  14. Scott Danforth

    removing paint from gel coat

    Lacquer thinner to remove, then 600 grit, then 800 grit, then buff
  15. Scott Danforth

    I/O (Sterndrive) Conversion to Outboards

    I/O boats have no HP rating
  16. Scott Danforth

    Ideal cylinder head temp range force 50 hp

    Water pressure is a better indicator of issues than a temp gauge. If water pressure goes low, or to zero, you will see it on the gauge long before the temp gauge would move
  17. Scott Danforth

    Favorite motor flushers?

    I use 2" painters tape to keep my muffs in place
  18. Scott Danforth

    OMC Cobra 305/350 Coil wiring

    No, only when the key is on and the motor is running
  19. Scott Danforth

    Broken gear lube fitting

    Because it's cheap and they only care about the profit margin
  20. Scott Danforth

    What control cables are these?

    doubt they make adapters. cables wear out. suggest new cables
View older results
Top