Search results

  1. Bondo

    First time water in bellows

    Ayuh,..... The A1, GenII is like that too,.....
  2. Bondo

    What is it like owning a 20yr old merc cruiser on a trailer boat?

    Ayuh,...... Donno,..... Never had one that New,......
  3. Bondo

    First time water in bellows

    Ayuh,...... Donno,.... Maybe with enough josslin' 'round, ya mighta hit it,..... I use Power Tune to install those lockin' rings,..... DonS taught me that one,..... 'n perfect seal,..... ;)
  4. Bondo

    se106 stern drive

    Ayuh,..... Welcome Aboard,...... The Sei can use Oem Merc parts, or aftermarket Merc parts,.....
  5. Bondo

    I/O Exhaust Riser life in Fresh Water environment

    Ayuh,..... They'll last pretty much forever in freshwater,..... Worst I've ever seen, were easily fixed by flat filin' the manifold/ riser gasket surfaces,....
  6. Bondo

    Restoring my Y pipe

    Ayuh,..... That's a mighty fine job,..... Probably deeper than I would go, even though I do, do the weldin',.... My "Machine Shop" is a grinder, 'n a drill press,...... I am tempted to remake a y-pipe to point forward, under the deck height, for the Atlantis project with the forward motor/...
  7. Bondo

    Throttle/Shifter - No Fwd

    Ayuh,..... Welcome Aboard,....... I haven't had a controller like yer's apart, so I can say what, or where to look,..... What I can do, is move this thread over to the forum that deals with cables, 'n control boxes,....
  8. Bondo

    Bad 1970 Mercruiser Engine, Please tell me there is still hope.

    Ayuh,..... The largest, most complete data base, worldwide knowledge archive, Is the Repair, 'n Restoration forum, right here at iboats,..... Again, as noted above, investigate the condition of the hull 1st, before you even consider goin' out on the ocean,..... or spendin' a dime on any...
  9. Bondo

    autopilot for 1988 mercruiser 5.0 alpha1 gen 1

    Ayuh,..... Those both appear to be hydraulic powered after a quick duck duck go search,..... I have a Raymarine Sport Pilot II on one of my barges,...... If yer lookin' to use it trollin'/ fishin', you might be disappointed,..... I was,..... With mine, it was Ok goin' down-wind...
  10. Bondo

    Looking to buy a 1976 starcraft holiday 21 ft. With a 165 6 cylinder engine. Engine is locked up,and was wondering if possible to rebuild that engine?

    Ayuh,..... Welcome Aboard,...... What drive is it,..??
  11. Bondo

    Removing Old Bellows Glue/Adhesive

    Ayuh,.... Try a dremel, 'n little brass brush,.....
  12. Bondo

    Waste storage tank

    Ayuh,..... Welcome Aboard,...... It's amazing that it's Only the motor ya gotta move outa the way,......
  13. Bondo

    fuel lines 1980 2.5L 120 hp Mercruiser

    Ayuh,..... Should be no vacuum, just a port to dump excess gas straight down the throat of the carb,..... Yer carb with a vacuum port, makes me wonder whether it's a Marine rated carb,.....
  14. Bondo

    125 hp on an 18 ft tri hill

    Ayuh,...... What does it do now, with the prop on it,..?? What are the rpms at Wot, light load, trimmed out,..??
  15. Bondo

    12 volt issues

    Ayuh,..... It takes some wigglin', but ya, it pulls straight out,....
  16. Bondo

    Volvo Penta in Bayliner 1989 runs in start position but not in run position

    Ayuh,...... Sounds like a key-switch issue, as that's where the ignition circuit gets it's power,.....
  17. Bondo

    Slow leak from top cap plate of Bravo 1

    Ayuh,..... Welcome Aboard,....... So long as it's been tipped full down to drain the waterline, you should be just fine,.....
  18. Bondo

    Block sealant...in a raw water system

    Ayuh,..... Not the best choice, as yer crack is so close to the head,.... Stitching utilizes tension to hold 'em in place, 'n being at the top of the block, the head bolts are already tryin' to pull that area up,.... Addin' stitches will increase the upward pressure, probably causin' an...
  19. Bondo

    12 volt issues

    Ayuh,.... Welcome Aboard,.... Start by cleanin' to shiny metal Clean both battery cables on both ends,......
  20. Bondo

    Outdrive Motor will not turn off - again

    Ayuh,..... Start by cleanin' to shiny metal Clean both battery cables on both ends,...... Then find a Volvo wirin' diagram for yer trim system, 'n follow it through,.... I suspect the problem is at the pump wirin',....
Top