Search results

  1. Bondo

    New gimbal bearing, can’t get alignment tool in coupler

    Yes,...
  2. Bondo

    New gimbal bearing, can’t get alignment tool in coupler

    Ayuh,..... Welcome Aboard,....... When ya had the alignment bar just barely into the coupler,..... Did ya Wack the bar good 'n hard, up, down, left, right,..??..??
  3. Bondo

    Gas vapor out the secondaries at WOT

    Ayuh,..... Welcome Aboard,..... Now is also the time to figure out what caused all this damage,...... My waGuess is, detonation, brought on by a lean condition,.....
  4. Bondo

    Cracked upper unit housing at spanner nut

    Nope, it's got studs, not bolts to hold the lower,.....
  5. Bondo

    Outdrive Motor will not turn off - again

    Ayuh,.... You've got some screwy wirin' goin' on somewhere,..... At that switch, red should be power, blue should be up, 'n green should be down,..... Ground should be from the pump motor to the battery,....
  6. Bondo

    Mercruiser 6.2l 300 (2018) fuel oil mixture prior to winterization?

    Ayuh,..... I don't,..... but if you insist, just pour abit of oil into the fuel filter with gas, 'n run it abit,.....
  7. Bondo

    No beep at key turn after boat upgrade

    Ayuh,..... The sensors provide the ground to sound the buzzer,....
  8. Bondo

    Block sealant...in a raw water system

    Ayuh,...... You could try AD's idea,..... I'd probably just let the rust seal it up, 'n replace it when ya can,..... I doubt any block sealer will work,..... maybe,....
  9. Bondo

    Test stand running 70's 350 water hook up

    Ayuh,...... Rule #1 with boats,...... Bow Up, Plug Out,......
  10. Bondo

    5.7LX rebuild question

    Ayuh,....... You should probably pay close attention to what yer doin' with yer right hand, but that combo ain't necessarily, inherently a bad thing,..... If yer raw water, in salt, go for a cast iron, vortec bolt pattern intake,.....
  11. Bondo

    Cracked upper unit housing at spanner nut

    Ayuh,...... Agreed,..... It's broken well beyond the threads,.....
  12. Bondo

    Outdrive Motor will not turn off - again

    Ayuh,.... Welcome Aboard,..... Who's motor, 'n drive,..?? Which ones,..??
  13. Bondo

    Lower Transom/Keel repair

    Ayuh,..... Welcome Aboard,....... That's certainly on odd Smash,..... Appears to be caved in right 'bout where I'd expect to see the bottom of the transom wood, inside,...... Do you weld aluminum,..?? some boat seams have a sealer that kills any chance of a good clean weld,.... What...
  14. Bondo

    some useful information on 5200, 6,000 and 7,000 lb axles (bearing/hub differences)

    Ayuh,...... Very Cool, Lou,......
  15. Bondo

    Hi from Newfoundland Canada :) Intro Fourwinns Fling

    Ayuh,...... Welcome Aboard,...... Scroll down to the Jet ski forum,..... That's where yer driveline is discussed,..... Maybe some motor cross over in the Johny/ Rude outboard forum,......
  16. Bondo

    5.7LX rebuild question

    Ayuh,..... For the money, 'n talent it takes to do what yer sayin',..... You could be boltin' yer accessories onto a brand new long block motor,..... Perfect time to up date to Vortec heads,.....
  17. Bondo

    Valve lifter reassembly SBC

    Ayuh,...... They're Hydraulic,..... No oil, no work,.....
  18. Bondo

    Random knock over 4k RPMs...

    Ayuh,..... 1st thing I'd do is dump the fuel filter, 'n look for water/ ethanol sludge,....... If it's a lean detonation, every knock ya hear, is abit of yer pistons goin' out the tailpipe,.....
  19. Bondo

    Mercruiser 6.2's port runs rich

    Ayuh,..... The '06 date probably helps some, but the serial number is kinda important, especially for the electronic motors,.....
  20. Bondo

    Motor question

    Ayuh,..... So long as you've got all the bits, 'n pieces from the original bravo, it'll bolt up with a few up grades,....
Top