Search results

  1. alldodge

    Trim Sender/Limit Mercruiser

    Might not be adjusted correctly Use a ohm meter and check continuity with drive down across the 2 leads from the limit
  2. alldodge

    Mercruiser 3.0 Alpha one gen1 backfires

    Do check the distributor to verify the hold down bolt is tight and it cannot be turned
  3. alldodge

    Mercruiser 3.0 Alpha one gen1 backfires

    Welcome Start by doing a compression test Most likely you have a burnt or warped valve
  4. alldodge

    New boat project need help gm 4.3l omc

    JB Weld has fixed some blocks but depends where the crack is and how well it was cleaned and made ready. Might be able to get a Truck 4.3 out of the junk yard
  5. alldodge

    '23 Merc 15hp EFI alarm

    Doing your line of work I would strongly suggest getting Diacom software from Rinda. Just to many sensors to take a WAG at it
  6. alldodge

    4.3 l engine swap on a Tahoe q4

    No real tricks, just need something longer or drive boat under something Good sturdy tree, hire a wrecker, make a A-frame with chain hoist
  7. alldodge

    Sank the 'ol girl!?!

    Yep, high school days
  8. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    Need line wrenches https://www.amazon.com/line-wrench-set/s?k=line+wrench+set
  9. alldodge

    5.0 GXI Cracked Block Need Help Sourcing New Parts

    That's a MEFI 3 so your golden so long as someone has a Bin file. Most 3's are lock but with the right Bin file can wipe it out and reload using MefiBurn A 555 is the next gen ECM after MEFI
  10. alldodge

    5.0 GXI Cracked Block Need Help Sourcing New Parts

    Unless it's a MEFI then no. Have not looked it up but I'll bet you have at least a 555 and while some have been done, don't know about the long term success rate. Anything above the 555 ECM , not going to happen
  11. alldodge

    2016 Mercruiser 6.2L ECT DTS Axius Cooling System Issue

    Formula yes, BB ah no
  12. alldodge

    2000 Crownline Battery discharge 8 amps.

    Welcome aboard When you disconnected the ALT did you disconnect all wires or just the main orange wire?
  13. alldodge

    Running hot?

    Maybe but after your testing you will know better
  14. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    The lines should not need any tape.
  15. alldodge

    Lowering the bunks . . .

    If lowering doesn't get you where you want, could change to low profile LT tires. something like 205 or 195 10 ply
  16. alldodge

    5.0 GXI Cracked Block Need Help Sourcing New Parts

    Not going to be able to use the ECM on anything but a stock 5.0
  17. alldodge

    2005 Triton FS 18

    Should be where all are Was there any water in the boat when you pulled it out?
  18. alldodge

    Constant 'Two Beeps' from my Four Winns 4.3

    Yes,
  19. alldodge

    5.0 GXI Cracked Block Need Help Sourcing New Parts

    long block https://www.michiganmotorz.com/5-0l-vortec-marine-engine-1996-current
  20. alldodge

    Constant 'Two Beeps' from my Four Winns 4.3

    I called it a switch but its actually a sensor, and it tells the ECM if water pressure after the raw water pump is low. Located above and at the rear of the motor on the power steering cooler, item 14 in link post previous Yes it does look a little low. It should not be full but right at or...
Top