Search results

  1. A

    Silliest Question on Fuel Mix - Thank you for your patience

    You and I would get into a lot of trouble, however when you live out in the country as I do, you can see the county doing it all the time. They also use old motor oil and ATF mixed together to treat wood on trailer decks and as markers along parking areas. Today they only care where there is...
  2. A

    1978 Johnson 140hp running rough. Need advice

    I would never use premium fuel if the mfgr recommends regular grade. Doing so can make your engine less powerful as premium fuel burns slower. Numerous studies have shown this, if your engine actually runs better, then you have issues besides fuel.
  3. A

    Random

    3/4 bottle of wine....I would get lucky for sure !
  4. A

    Bellow condition??

    If your questioning it....it needs to be changed...sooner rather than later !
  5. A

    Silliest Question on Fuel Mix - Thank you for your patience

    Anyone that thinks they are saving this planet by cutting back on their two stroke oul, needs a reality check. The amount of oil based products, spilled, wasted or intentionally put into the ground and atmosphere are so great, that two stroke oil pollution is a mere drop in an entire ship load...
  6. A

    Transom saver or no?

    Most savers that I have seen, have a spring loaded or a snubber that has some give under severe stress, yet keeps motor from flopping around. you don't want the motor to flop up and down, yet some kind of give or control in a severe situation. It is the constant flopping up and down that causes...
  7. A

    Silliest Question on Fuel Mix - Thank you for your patience

    My container says Pennzoil marine TCW-3 meets all mfgr requirements for tcw3 oils and suitable for use in air cooled two stroke engines. I have one container that states syn blend and another container that looks identical but no syn blend statement.....actually never paid that much attention...
  8. A

    Transom saver or no?

    This could be argued until the end of time....bottom line is, if your worried about transom weakness then buy a transom saver, if you think your motor mount is solid, then take the gamble. No one can make you decide, your boat....
  9. A

    28' Pontoon with 3.0 Mercruiser Prop

    Should of have tried one when Covid was running wild....might have been the cure !
  10. A

    Silliest Question on Fuel Mix - Thank you for your patience

    Actually been using Pennzoil marine two stroke oil for about as long as I can remember. Mfgr says it can be used in both air and water cooled engines which I have done with O issues. BP had a coupon for the quicksilver stuff so I bought some. Looks exactly the same even though that may mean...
  11. A

    1973 Starcraft SuperSport 16ft. restoration questions

    Can't remember how many times I have punished myself because I thought I would fix the issue soon, yet it got forgotten. Or the old favorite...won't hurt anything just this once ! I feel your pain and have been there many times..
  12. A

    Silliest Question on Fuel Mix - Thank you for your patience

    Many if today's synthetic two stroke oils darn near eliminate the smoke...I switched to some Quicksilver semi synthetic oil this season ( it was on sale) and my smoke is really noticeably less, I gotta look close and almost no odor.
  13. A

    Men, it is October

    Whew....at first I thought the headline was referring to " locktober" I have been told that some men are made to wear chastity cages during the month! " save those ta.. ta's"
  14. A

    Silliest Question on Fuel Mix - Thank you for your patience

    Always follow mfgrs instructions for best life and operation!! When you start cutting corners....problems often arrise....
  15. A

    Transom saver or no?

    Typical issue when maxing out the engine size on any boat, especially older boats built before the heavy four strokes came into play. Many are more than 100# heavier than there old two stroke models. Hanging out over the back enhances that leverage....
  16. A

    Transom saver or no?

    It will tilt, but needs to be locked into place. The power trim on a motor is strong enough to hold it in position, but without that, the motor can flip up and down on rough roads. In the past, I have made a wood block to fit into the tilt mechanism to hold the motor in position, then add a...
  17. A

    Source for bearing buddies rubber plug

    We pulled neighbors trailer out of the weeds after sitting for over 20 years unused. Tires were rotten, pulled the hubs and bearings had no corrosion at all. Repacked and ready to roll....you hat was last spring, approx 200 miles on them since. You might be in a salt water atmosphere with...
  18. A

    New Stuff on Vehicles likes/dislikes

    That is the vehicle the gov't was after when they were taking gas guzzlers off the road with the stupid buyout. Taking one of the best vehicles off the road because it used a little more fuel. Just think about all those great vehicles trashed and taken out of service !
  19. A

    Transom saver or no?

    How sturdy is the transom the 35 is mounted on...what us the max hp rating on the boat ? Does the motor flop around when going down rough roads ? If your motor is at max capacity, or your transom can flex, or your motor can flop around ....then yes, a saver is recomended. If boat can handle...
  20. A

    Source for bearing buddies rubber plug

    They don't go bad just sitting there....adding a couple squirts of grease every so often lets you see if there is any water inside....if so, you need a repack and seals. My boat gets used once a week from May thru Nov....in my 40 years of using some form of bearing buddy, never have had any...
Top