Search results

  1. Scott Danforth

    2014 GMC Sierra AC

    Both the vac pump and AC compressor have a stretch belt. My personal favorite stretch belt tool is 2 zip ties and a remote bump start switch. One zip tie around the damper to act as a slide, one to hold the belt. Bump the switch twice, then cut the zip ties. However I have done the...
  2. Scott Danforth

    1988 candia 180 4.3

    make sure the points have been serviced, the dwell set, and the timing adjusted (after the dwell being set). if the dwell is off, the timing and power will be off.
  3. Scott Danforth

    2014 GMC Sierra AC

    GM Denso compressor and belts showed up today. just waiting the expansion valve kit (with seals, and desiccant bag) and the GM PAG oil. start R&R tomorrow if the temp is below 94
  4. Scott Danforth

    How to restore this 1961 hull?

    everything you need is in this sticky. links 14, 15, 13, 2, 3, 4a, and 4b will be the most pertinent
  5. Scott Danforth

    Private Boaters Vs Navy Ship

    Someone punched in the naval base on their auto pilot
  6. Scott Danforth

    Power Steering Cylinder Replacement

    Rebuild kit is cheap. You can rebuild it on your tailgate. New pump insert is $50, just insert into your current reservoir
  7. Scott Danforth

    Changing colour of gelcoat question

    I have over 28" span with 1/2" balsa for the deck sole in the Rogue. There is almost 1/8" of fiberglass on both bottom and top However there is a rib every 24"
  8. Scott Danforth

    2014 GMC Sierra AC

    Amazon has a replacement condenser coming on Monday.. I hope it arrives undamaged
  9. Scott Danforth

    2014 GMC Sierra AC

    With a record heat advisory....... lol
  10. Scott Danforth

    2014 GMC Sierra AC

    AC systems are easy. If there was freon left, I would consider having it reclaimed. I do wish I had the larger AC service cart /vac/etc I had access to years ago vs a small vac pump Dealing with damaged parts from Amazon is the biggest PITA
  11. Scott Danforth

    2004 5.7 GXI Overheat - Pump? Impeller?

    Here is the most up to date parts lists. https://www.volvopenta.com/shop/
  12. Scott Danforth

    4.3 l mercruiser one piece exhaust manifold temp senor install

    To get a double wall casting, there are two sand cores. They would shift during the process. You don't need a temp sensor
  13. Scott Danforth

    2006 Volvo 5.0 Penta water ingestion

    I'm leaning towards your boat has 800-1000# of water in the foam and it's riding low
  14. Scott Danforth

    4.3 l mercruiser one piece exhaust manifold temp senor install

    Upgrade to the 2-piece and get rid of the failure prone batwings
  15. Scott Danforth

    Need Advice

    get the motor height right, then adjust pitch. because a pontoon loading affects the running so greatly, they should have hydraulic jack plates on them from the factory
  16. Scott Danforth

    2004 5.7 GXI Overheat - Pump? Impeller?

    Check the raw water supply fitting at the forward edge of the outdrive where the hose attaches. If corroded, replace it Guessing this is a new to you boat. What other maintenance have you done they the prior owner neglected?
  17. Scott Danforth

    Alpha I Gen II impeller install.

    They are the first few threads on the top of the forum with the post-it note icon
  18. Scott Danforth

    Alpha I Gen II impeller install.

    there are also videos in the stickies that were done by Achris
Top