Search results

  1. Scott Danforth

    1993 stratos 274 fish and ski, owners manual? Aerator functions?

    First, welcome aboard An early 90s stratos that has been sitting kin a back yard may be a big project The owners manual for the boat would just be a 4 page safety brochure and a list of servicing dealers Wiring diagrams generally do not exist. There are 12 boat manufactures that made...
  2. Scott Danforth

    Trailer Bunk Lag Screws

    95% of stainless is 18-8 or 304 Not 316 Galvanized steel is about 4x the strength, and normally lasts as long as the wood
  3. Scott Danforth

    Mercruiser 170/470 Starter Question

    Take your starter in and get it repaired properly
  4. Scott Danforth

    2008 Volvo Penta 5.0GL Carb Problems

    No, the Welsh plugs over the emulsion tubes. Cover over the idle screws can be removed with a small screw and prybar if you can't get it with a pick
  5. Scott Danforth

    Engine Oil viscosity mixing?

    I would run Rotella 15W40 diesel engine in your flat tappet cam motor
  6. Scott Danforth

    2008 Volvo Penta 5.0GL Carb Problems

    dont try to remove the welsh plugs from the metering plates you will destroy the metering plate. dont try to remove the air bleeds unless you want to machine for adjustable air bleeds. you test a power valve with a vacuum pump. however with that amount of corrosion, the power valve in the...
  7. Scott Danforth

    My 2015 grand dodge grand 's towing capacity

    and the boat he is looking at may be stolen / improperly registered.
  8. Scott Danforth

    2008 Volvo Penta 5.0GL Carb Problems

    you have to run either soft copper wire or fishing line thru each passage to ensure they are clean. I have had some carbs with so much crud in the passages I have had to use my pin drills to open them up. from what you describe you have blockage in at least two circuits. at idle there should...
  9. Scott Danforth

    Rigging flange

    like these? https://thmarinesupplies.com/collections/rigging/products/cable-boot
  10. Scott Danforth

    1994 Tracker Pro Deep V17 corner caps

    then I would visit your local aluminum fabricator and have them made. these parts are not only brand specific, they are hull specific. you wont find parts from another boat, unless its another tracker of the same hull (V17)
  11. Scott Danforth

    Does the antifreeze you use really matter?

    Having done the experiment to verify the freezing temps in college nearly 40 years ago. each brand has a slightly different volumetric ratio as there is already some water in their EG mix. read the labels, there will be a chart on the back of the bottle. It was prestone that we tested, full...
  12. Scott Danforth

    I hit a rock

    no, the outdrive from a 2.3 has different gearing than your 4.3. way too far apart to get a prop to work you could just have a bent prop shaft. in that case, just replace the prop shaft.
  13. Scott Danforth

    1994 Tracker Pro Deep V17 corner caps

    reach out to your local tracker dealer.
  14. Scott Danforth

    Bought my first boat to cut, gut and rebuild from bow to stern, including engine. Killed my back and suffered the wrath of the fiberglass demons

    I redid my transom, bulkhead, and aft stringers in a storage unit. Do the grinding outside the unit in the parking lot.
  15. Scott Danforth

    My 2015 grand dodge grand 's towing capacity

    Yes, that boat is not a 1996 Doral. Google 1996 Doral 216cc (the smallest cuddy the have) and you will see. Then Google 1985 Bayliner Capri 1850 cuddy. The boat you are looking at does not match the description 1985 Bayliner Capri 1850 cuddy 1996 Doral cuddy
  16. Scott Danforth

    Careful what ya wish for…

    Go to the 4th sticky down, start with link 14
  17. Scott Danforth

    Boat

    If it's stolen.....run away and call the authorities. They will do a HIN check and a registration check along with inspection if you go down the "salvage" path
  18. Scott Danforth

    My 2015 grand dodge grand 's towing capacity

    Going to agree, looks like a mid 80s Bayliner capri cuddy, including the little bend in side window top rail The big red flag is why is it being sold as a Doral? Look up the HIN
  19. Scott Danforth

    Bought my first boat to cut, gut and rebuild from bow to stern, including engine. Killed my back and suffered the wrath of the fiberglass demons

    Modify the trailer to a swing tongue If it's a height thing, pull the wheels off and run the trailer on the hubs in 2x6's on the garage floor
Top