Might want to contact them to see if they have a chart specific to your model year
https://www.seafoxboats.com/wp-content/uploads/2020/10/TRAILER-SPECS-MY2020.pdf
Then the question becomes....does the bunk make full contact with both sides of the hull in that location?
FWIW: Grady wants the stringers sitting on the bunks. I would image most other boat builders do as well.
Where are your stringers in relation to the bunks?
Wet - sealed unit, can be mounted in the "wet" location
Vented - unit is open to environment, must be mounted in a "dry" location
Both are capable of charging a battery under load.
The difference being that the vented unit has a higher charging capacity based solely in it's ability to...
My bunks are 4" x 6". They don't bow between the heads and ends of the bunks.
I would run a straight edge cross the brackets width wise in all three locations and measure the distance from the bunk to the frame to compare.
Could be a frame has bowed in the center over time.
Guessing you meant 35 inches…
We got snow twice this year. Both times 3-4”, both times pretty much gone by noon.
Don’t like snow, never have. Incompatible with my preferred attire…shorts and flip flops.
Bear in mind you’re working with plastic carbs with self tapping screws.
When putting a screw back in, I turn the screw counter clockwise until I feel the threads “sync” then start tightening from that point. The last thing you want to do is cross thread or cut new threads, Torque values are...
How did you determine the armature and field are not compromised?
Testing is a $rap shoot w/o using a Growler to check it out
No right or wrong way to install wave washers.
Do you have an end play specification to check your work?
I've not soldered a VHF antenna connector in years for just that reason
Do yourself a favor and buy one of these PL-259 Gold-Plated Center-Pin Connector
VHF is line of sight. You can pick up some crazy bounce now and then, but generally speaking if you can't see it, you can't hear it...
They vary quite a bit by year. The 2024 Tesla S Plaid is advertising at 1.99 seconds. Edmonds tested the 2024 base S series at 2.9
What percentage of car owners drive in excess of 340 miles on a daily basis?
BIL has owned a Model S going on 3 years now. Drives 60+ miles to and from work each...
I’m not seeing the “heavy” part.
Curb weight of an “extended range” Tesla 3 is #4,048, 0-60 = 2.3 seconds
Curb weight of Dodge SRT Hell Cat is #4,438
0-60 = 3.7 seconds
Depends on what is in the cable bundles.
Coiling power and digital signal wires in the same bundle can setup magnetic fields scrambling digital signals.
ECM are adaptive controls. They store programed values in EPROM and working/actual (sensor) readings in ROM.
A “hard reset” in effect replaces the “working” values with the preprogramed values stored in EPROM
MEFI 3 manual
Non-Scan Diagnosis Of Drivability Concerns (No DTC's Set)
If a...
