Search results

  1. dingbat

    No data to vessel view mobile module

    No. A gateway is typically connected directly to the CAN connector on the motor if required. The junction box is just a breakout point for multiple gauge /sensor applications. This may be of some help while troubleshooting https://www.drev.se/Upload/DocumentManager/mercruiser/smartwire.pdf
  2. dingbat

    Out on the Lake Pictures

    Same for Deep Creek Lake in Maryland.
  3. dingbat

    Out on the Lake Pictures

    Except Hagerstown is in Maryland.
  4. dingbat

    No data to vessel view mobile module

    You're dealing with a digital system. The fact that you have nothing means that you have issues with the pcm or gateway module. Check to make sure you have power to the harness then unplug and reseat the main and gateway connectors. Would hurt to put a bit of dielectric grease in the...
  5. dingbat

    Thinking about an upgrade for the tow vehicle

    Remember the F150 went to an aluminum body in 2015. Lost almost #700 over the 2014 models.
  6. dingbat

    Out on the Lake Pictures

    Drive by it all the time on the way to Buffalo. Lake or Reservoir? Just assumed it's a resevoir given it's location
  7. dingbat

    Question please on angler boat i bought

  8. dingbat

    Question please on angler boat i bought

    Never heard of a "Dual Helm" Dual Stations, yes
  9. dingbat

    Question please on angler boat i bought

    Fancy name for a "Coastal" oriented Bowrider
  10. dingbat

    Question please on angler boat i bought

    It's an Angler 204C dual console A "Dual console" is in effect a walk through windshield.
  11. dingbat

    battery charger alternative

    Rarely, if ever do people put enough hours on a boat to fully recharge a starting battery each outing. Guessing your two batteries in series are ~80 amp hours range. If you discharge the batteries to 1/2 capacity (80 amps,) your looking a recharge time in hours = 80 amps/charger output
  12. dingbat

    Boat Loading Problem

    My boat is 5k. Typically power load, but can pull boat by hand to within 18" or so from the winch. Connect strap, pull to level ground and winch the last foot or so to the bow stop Right depth and wet bunks is the key. Make sure the entire length of the bunks are wet before loading Guide poles...
  13. dingbat

    6 year anniversary of quitting smoking, yay me!!!

    Pack a day since high school. Went on a 3-day business trip with a non-smoking colleague. Didn't smoke out of courtesy. Only craving came with my morning coffee. Got me thinking about the other 19 per day. My office was right outside the exit to the smoking area. Started turning down...
  14. dingbat

    6 year anniversary of quitting smoking, yay me!!!

    Congrats....going on 30 years for me.
  15. dingbat

    Fuel water separator and fuel filter on 3L

    Wasn't fueling related. The Earth, Sun and Moon aligned with a lingering TD (6" in 3 days) to fill the fuel fill recess in the gunnel with enough water to leak through the vents in the fill caps.
  16. dingbat

    Anchor line

    Need to keep scope to a bare minimum when fishing structure or living lining with the fleet. I carry 250' of 3/8" DB with 10' of 3/8" chain and a #16 Danforth.
  17. dingbat

    Fuel water separator 2000 200hp Saltwater series 2 stroke

    Racor B32014 with a clear bowl Typically go three seasons before filter can starts to rust out.
  18. dingbat

    Fuel water separator and fuel filter on 3L

    Most people don't understand the saturation point of E10 varies with the temperature of the fuel. Fill up with 90F fuel and it cools to 80F at night, you're dumping water in the bottom of the tank. Works the other way as well. Pump 60F fuel from an under ground tank into a tank of 90 F fuel...
  19. dingbat

    Fuel water separator and fuel filter on 3L

    Not necessarily......E10 can hold approximately 0.5% water at 68F (.64 ounces in a gallon, or 12 ounces of water in a 20-gallon gas tank) I hold 150 gallons of fuel. At 68 degrees, that is 3/4 gallon of water each time I fill up
  20. dingbat

    Fuel water separator and fuel filter on 3L

    Components used/mounted in enclosed area must be UL listed......2.5 minutes exposure to open flame You can use a clear bowl on an I/O, just can't be mounted in an enclosed space (bilge) or same compartment as an internal combustion engine, ie dog house...
View older results
Top