Search results

  1. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    your starter has 4 connections B terminal goes to the battery. this is a high-current power supply connection to the stater. the Ground connection via the block. this is a high-current power supply connection to the starter the S terminal which is energized by the crank position of the key...
  2. Scott Danforth

    Engine RPMs Fluctuating

    start your own thread
  3. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    NO
  4. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    yes. the R terminal is connected internally to the B terminal once you energize the S terminal
  5. Scott Danforth

    Engine RPMs Fluctuating

    Check fuel pressure Check compression Pull injectors and have them cleaned Check IAC , replace if the pintle is stuck
  6. Scott Danforth

    1989 Mastercraft prostar 190

    Maybe a much newer boat than a 35 year old one
  7. Scott Danforth

    Engine RPMs Fluctuating

    And what are you working on? There are many Volvo Penta motors
  8. Scott Danforth

    New guy, floor repair questions

    Buy a boat less than 15 years old
  9. Scott Danforth

    I have a 1986 Bayliner Capri with a 4 cyl volvo engine with a volvo Penta 270 outdrive.

    There is no pump in the drive. It's on the front of the motor
  10. Scott Danforth

    T-Stat for closed loop cooling system?

    It does require a thermostat However the keed needs to be installed properly What kit? What size HX (should be at least 5"in diameter and about 2 ft long)
  11. Scott Danforth

    New guy, floor repair questions

    The wood structure of your boat has rotted away
  12. Scott Danforth

    New guy, floor repair questions

    ^× 1000000 He is right. A simple hull restoration is about $4000 with today's prices ,(no motor or interior)
  13. Scott Danforth

    I have a 1986 Bayliner Capri with a 4 cyl volvo engine with a volvo Penta 270 outdrive.

    Raw water pump is on front of motor. Replace the impeller and the raw water inlet fitting along with all the other maintenance the prior owner didn't do You are running on muffs, correct? And not trying to suck up from bucket
  14. Scott Danforth

    Triax Marine Gear Oil

    Amsoil is my preferred gear oil in VP drives
  15. Scott Danforth

    projects other than boats

    Using my hotrodders thread, then linking back https://www.hotrodders.com/threads/1952-fiat-topolino-belvedere-project.550685/?post_id=4853322&nested_view=1&sortby=oldest#post-4853322 Have 4 other forums I could use as well.....LOL
  16. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    The R terminal was used for points ignition. It's common with later motors to not have anything wired to it
  17. Scott Danforth

    projects other than boats

    Just a little water. Mill Creek now 3' above the road Not sure I'm still on the road. Fording 2 feet of water .
  18. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    Yes, The R terminal provides power during cranking Then after cranking, the oil pressure switch provides power unless the motor dies and oil pressure goes away. Then it kills power to the fuel pump meeting the requirements for shutting off fuel I currently run both ignition power and fuel...
  19. Scott Danforth

    projects other than boats

    maybe this will work
  20. Scott Danforth

    projects other than boats

    so...... trying to figure out how to get home as all the major roads around my subdivision are closed due to flooding would post pics..... however......
Top