Search results

  1. dingbat

    225 mercury saltwater temperature rising after shut off

    Have you checked to make sure the alarm is real? Swap sensors or confirm with heat gun?
  2. dingbat

    ECM Swap ? Plug and play ???

    At issue is not the technology or cost, it’s the skill sets required to support them. It’s gone from turning wrenches to plugging in a laptop. The younger guys at work are constantly making performance modifications to their cars. With that knowledge, they too are only limited by budget I can...
  3. dingbat

    225 mercury saltwater temperature rising after shut off

    Peeing isn’t a good indication of internal flow. Some are plumbed separately from the cooling loop Increasing temp at shut off would point to a “hot spot” within the cooling circuit. Check the poppit valve
  4. dingbat

    Minn Kota Trolling Motor Faulty switch or coil?

    Glad you sorted it out. For giggles, check continuity through the switch from the power input terminal to the other terminals. Has to be something on the input side of the switch. Only point of failure common between the speed outputs
  5. dingbat

    Minn Kota Trolling Motor Faulty switch or coil?

    DC circuits are problematic to troubleshoot in that current takes the path of least resistance to ground, to the point that it will back feed to ground through other circuits. You can not verify component integrity with the components still in the system and powered up. They must be isolated...
  6. dingbat

    engine cover gas shock mount

    They are a dime a dozen on the open market. Search -gas springs, marine Need rod diameter, overall length, stroke and mounting details, Should be easy to match up once you collect the information
  7. dingbat

    One battery losing power

    When was the last time the batteries loaded tested? Disconnect the batteries from each other and test independently. A fully charged 12 volt battery should measure roughly 12.7 volts. A battery is considered dead at 12 volts
  8. dingbat

    Minn Kota Trolling Motor Faulty switch or coil?

    Proves nothing…. Simple selector switch. The odds of all 5 contacts being bad is next to zero. Did you check continuity between C terminal and the other 4 speed contacts? If that checks there is nothing wrong with the switch. What voltage do you get between C terminal and ground!
  9. dingbat

    Artificial Intelligence parts finder

    http://www.tmssouth.com/stem-finder2/stem-finder.html
  10. dingbat

    Minn Kota Trolling Motor Faulty switch or coil?

    Looking at the schematic you have a switch and a “speed coil” in the circuit. No functional description of the coil but it feeds what appears to be a simple speed selector switch. Terminal C is the incoming power to the switch from the speed coil. Check incoming power then check for...
  11. dingbat

    Artificial Intelligence parts finder

    Most faucet parts are common, off the shelve components. O-rings, washers, etc. As long as you have the old part, you can find new
  12. dingbat

    OX- 66 - 2 stroke - 250 Yamaha , Think I have fuel issue after filter change ?

    Trapped air can be problematic when changing the separating filter. Some people fill the bowl with gas prior to installation, but that can be dangerous and messy. When changing the filter I run the motor for a bit to fill the carbs with fuel. I then change the filter and start the motor again...
  13. dingbat

    Burned boat and insurance offer

    If it's the 1996 boat and motor listed in your profile you are not going to be happy with the book value assigned to the boat. Assuming you have insurance on the boat, I'd submit a claim to your insurance and let them argue it out Good argument for the need of an Agreed Value policy on an...
  14. dingbat

    Oil in breather hose/2012 Mercury 20 4 stroke

    4 stroke outboards are notorious for “making oil”. Check to make sure the oil isn’t over filled or smells like gas.
  15. dingbat

    1975 Johnson stinger 75 hp

    Sounds like you need to start with the basics…. Compression test and spark jump test.
  16. dingbat

    Grew 178grs outboard oil filter

    You may have a mesh filter on the intake at the bottom of the oil tank but there is no oil filter per say on a 2 stroke
  17. dingbat

    Transducer mounting options?

    I guess I’m fortunate that my transducer bolts to the bottom of the mount. Only the bottom 1/8” of the transducer extends below the hull.
  18. dingbat

    Transducer mounting options?

    Most transducer mounts were “breakaway” until the large, side scan transducers hit the market. The best thing I ever did was install a transducer board on the transom. Drilled the two mounting holes. Filled with epoxy then back drilled so no glue involved in the installation. The 3/4”...
  19. dingbat

    2014 4.3 liter TKS bogs after running 35 knots for 45 minutes.

    Step 1 - check fuel filter for water…..
  20. dingbat

    1992 Mercury 100 HP -Inline Fuel Filter

    Filter are filters…. The difference is the filtration rating and pressure drop through the filter You could not filter two stroke oil out of the gas if you wanted to ;) The 5/16” line is a problem as it restricts the flow of fuel. Need a 3/8” in-line filter, if anything The filter in question...
Top