Search results

  1. S

    1988 Evinrude 120 V4 -Suddenly going into SLOW Mode at WOT. Video included

    From everything I've read it 2500 for your motor. Did you read about the diod that can go out in your harness and cause it?
  2. S

    1986 6 hp Johnson Silencing Pads

    Excellent dig Vic...well done!
  3. S

    1988 Evinrude 120 V4 -Suddenly going into SLOW Mode at WOT. Video included

    Not sure 3500 would be considered a "slow mode" my outboard, while quite newer, takes me down to 1200 rpm's. Seems like 3500 if your running hot or low oil wouldn't be very "safe" did you read somewhere that that is the safe or slow RPM? Here is a screen shot of something I found with a...
  4. S

    1988 Evinrude 120 V4 -Suddenly going into SLOW Mode at WOT. Video included

    Neutral revving to that degree is not very good for your motor. A little rev to start it up is fine then you need to back off pretty quick and then let it warm up at a slightly higher idle. I too thought you would show us a video with it in gear doing what you said....that's the only way to test...
  5. S

    johnson 70hp 2 stroke 1995 shut down when warm

    Here is what I mean, 3 to 4 hours south of the border drive from you.....maybe. I didn't see any in Vancouver but I'm sure they come up. Older 2 strokes are on the way out so if your patient, you can find a used one for fairly cheap. If used correctly they are very reliable outboards. The lower...
  6. S

    johnson 70hp 2 stroke 1995 shut down when warm

    With your limited knowledge that's a tough one. You could pull the head and see if the gasket let go. You would also need to know why it happened. Usually cheaper and easier to find a new used outboard. Sorry it happened to you.
  7. S

    1985 evinrude 30 hp prop power issue

    Omc manual with sync and linkage adjustments. For some reason I thought you said the butterfly valves in your carb weren't opening all the way. Anyhow, here it is.
  8. S

    1985 evinrude 30 hp prop power issue

    Try this link. Older motor so not sure it's the same but I think it might be. The 3rd thing he does with the rod on the side under the flywheel is making sure the butterfly opens all the way. Also, revving the motor in neutral doesn't work because there is no load on the motor.
  9. S

    Etec forum

    Yes, I wrote it down incorrectly. It's a P and not an F. That solves that issue anyways.
  10. S

    Etec forum

    I had to click around and then I saw it. Thanks again for all your help.
  11. S

    Etec forum

    I couldn't find that, I'll look again. Thanks for the help by the way and the pdf. As far as the model numbers, I know the conversion, it's when I went to the place to buy parts online it doesn't show my model...just some that are like it. I guess trim relays and motors are all the same that...
  12. S

    Etec forum

    I registered, but couldn't find a way to post a topic?
  13. S

    Etec forum

    Anyone know if there is still a forum just for E-Tech owners? I used to go through e Nation but when BRP collapsed so did E- Nation. I joined up for Barnacle bills and I read posts but I couldn't find a way to make a post. There's some stuff on the hull truth but I ended up having the same...
  14. S

    1975 25hp sneeze, and screw?

    This is a little out of my pay grade and I'm not sure if this applies to your older motor. I had an 83, 30 horse and you had to run what I'm assuming is the timing quarter inch past the lines. There was an Evinrude update on that. My motor was doing the same thing, sneezing that is and once I...
  15. S

    johnson 70hp 2 stroke 1995 shut down when warm

    No worries, just thought you might want to know. Model number J=Johnson, 70=hp, T=trim and tilt, L=Long shaft, EN=year. Here is the conversion.
  16. S

    johnson 70hp 2 stroke 1995 shut down when warm

    Your outboard is a 1992 by the way.
  17. S

    johnson 70hp 2 stroke 1995 shut down when warm

    Might try a portable tank if you know someone who has one.
  18. S

    johnson 70hp 2 stroke 1995 shut down when warm

    Get the compression numbers to make sure the engine is ok and then start the fuel check offs if the compression numbers are still good.
  19. S

    johnson 70hp 2 stroke 1995 shut down when warm

    Do you have a built in tank or are you using portable tanks?
  20. S

    1968 Evinrude 6hp - 6802C - Gearcase Seal Kit

    Here is something odd and I'm not sure it even helps. When I plug in 6802 in the where I buy parts, just like you it comes up 1967. But when I go to leroysrambilings his chart has it as a 1968. I think that guess of the 67 to 68 has to be the one but then who knows. Another thing, if you click...
Top