Search results

  1. alldodge

    no electrical systems working

    Get a cheap voltmeter and attach the negative probe to a long piece of wire. Connect that wire to negative Bat terminal. Take meter and red probe and start tracing wires from starter to helm
  2. alldodge

    ignition switch

    Welcome Do think your talking about a lawn mower, could help us if you could tell us what are you working on. Merc, VP, other, which motor? Year can help but serial numbers in most cases are best
  3. alldodge

    2002 MerCruiser mx 6.2 mpi wont idle

    Welcome Could use motor serial number to make sure what you have Pulsing fuel pressure may be the regulator on the fuel rail Disconnecting temp sender will throw a code and can also supply more fuel. Sounds a bit like a vacuum leak, maybe the intake gasket Need to put a scanner on the motor...
  4. alldodge

    5.7 slave cylinder wiring

    You could wire up the newer style slave as in your pic
  5. alldodge

    5.7 slave cylinder wiring

    Measure from I to case ground, should read 0.00 ohms If you get something higher then it may go thru the coil
  6. alldodge

    5.7 slave cylinder wiring

    Agree FT has it 1 & 2. Put small Y/R wire on the I terminal and Black on other one. The coil needs a ground and in most cases doesn't care if it's on the "I" side or the other. Being DC it will still energize 3. The wires should go to the ALT as you listed unless the ALT was replaced with a...
  7. alldodge

    1976 Montego 16- The "Free" Puppy

    No reason to not leave it open. Do see if there is a drain and if should not be clogged
  8. alldodge

    Jabsco 37010 not pumping water in

    The valve may not be there, and if so then it wasn't needed for original install Agree with dingbat, if pump will not pull water then there is probably a air leak, either that or the impeller is not making good contact. There are different impellers, you sure you have the correct one?
  9. alldodge

    no electrical systems working

    Is the motor a GL and if it's a GL- which one?
  10. alldodge

    no electrical systems working

    Welcome Need to start tracing wires with a voltmeter Which 5.0 is it?
  11. alldodge

    I just got this rope and it has some frays.. Think it's OK to use??

    Always use Poly for any kind of toy, it floats, and you want it to float I would not use dyneema with toys, main reason is it's stronger then steel. While poly may not break if it gets wrapped around a limb, it has a better chance of not cutting it off. Case in point, gal got ankle tangled up...
  12. alldodge

    Jabsco 37010 not pumping water in

    Don't know much about them but manual shows a vent loop and vent solenoid. Does the raw water come from over board or fresh water tank? This manual shows loop on page 2 https://www.pumpagents.com/pdf/JabscoPumps/37010-0090.pdf
  13. alldodge

    Mercmonitor First Power Up - "Warning No Starboard Engine" (part 2)

    This is a write up I have saved Hello Folks; I have a 2006 Chaparral Signature 350 with twin 496 MAGs. Not originally equipped with vessel view or any SmartCraft accessories despite the engines being capable. I added a NMEA bridge to allow my Garmin ChartPlotter (7610xsv) to display engine data...
  14. alldodge

    Alarm capacitor 4.3L

    correct
  15. alldodge

    What does this marking mean on this new to me outdrive?

    AK - sound my cat makes when hacking up a hair ball
  16. alldodge

    I just got this rope and it has some frays.. Think it's OK to use??

    That kind of line is used for water sports, should not be used where a higher level of safety is needed. Many use it for dock lines, fenders and such I don't see any issue other then wonder what caused the damage
  17. alldodge

    Closed Cooling System Part # 860234A1

    Pic would help but my guess is the belt is not routed correctly Most serpentine belts rotate the circulating water pump in opposite direction of the crankshaft
  18. alldodge

    1984 Mercruiser 3.0 starter wiring help

    Welcome The pic has an error. Put orange wire on the white plastic fuse.
  19. alldodge

    Mercruiser 5.7 with V6-14 TB IV module??

    TB 4 and 5 get full time 12V when key is ON or when motor is cranking. So check to make sure your getting 12V full time
  20. alldodge

    Mercruiser 5.7 with V6-14 TB IV module??

    You have the old style which is classified as a 2 wire The kit comes with terminal connections to make it go from old to new style
Top