Search results

  1. alldodge

    Honda BF60A stumbles at high speed

    Not a OB guy but being EFI I would think something is clogged or a fuel pump (low/high) has an issue. Try to find the fuel rail feeding the injectors and connect a gauge
  2. alldodge

    Bravo 3 loss of lube oil - slowly then rapidly x2

    Agree with Dubs, it leaking that much I would look at the hose and fittings between transom and drive https://www.mercruiserparts.com/bam/subassembly/30971/952/180
  3. alldodge

    4.3 GL-C - Distributor clamp bolt

    Allen wrench with a hole drilled Search "Tamper resistant hex wrench" then find size 7/32, and do replace it California requirements
  4. alldodge

    winterizing a mercruiser 3.0 with sterndrive kept in water year round

    Need a marine safe heater. Something as simple as a incandescent 60watt bulb will keep the engine room warm. That said if there is any fumes in there and the bulb breaks there could be an explosion The blue hoses sounds like they go to a air pump connection on top. There is a hand pump used...
  5. alldodge

    winterizing a mercruiser 3.0 with sterndrive kept in water year round

    Welcome What are the 2 hoses your talking about for draining? Only way to do that and be safe is put a heater in the boat. I'm on the KY/TN line and it gets cold enough at times to freeze things pretty solid.
  6. alldodge

    Boat wont start

    On top the motor If you have 3 square relays then one of them is the slave relay If you have 2 square relays then the slave relay looks like pic
  7. alldodge

    Volvo 1000530 Cylinder Head Torque Specs

    Welcome I don't have a 125 manual, just a 120B/140A. Head bolt torque list 110 Nm or 8.1 Ft Lb in 2 passes
  8. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    I was able to look up the parts breakdown in link below but still not able to find service manual. Hope Muc can assist https://www.volvopentastore.com/
  9. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    Hey @muc can you assist?
  10. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    This is where I would go, they want the serial number or product number https://www.volvopenta.com/en-us/service-and-support/your-engine/manuals-and-handbooks/
  11. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    Welcome Looking at the vid it appears there was water or some other liquid inside the drive. If that is correct then pressure test is done incorrect, should be dry and only with air. Pressure should be no higher then 10 psi and lower is better Need to start with the manual for the drive...
  12. alldodge

    Texas Trailer Registration Help!

    Welcome Not from TX but I find need form VTR-141 is used for homemade https://www.txdmv.gov/sites/default/files/form_files/VTR-141.pdf TxDMV states Note: A manufactured trailer with missing paperwork cannot be registered as a homemade trailer. Here is the link for assembled trailers...
  13. alldodge

    2013 Mercruiser 3.0 MPI (engine rebuild)

    Yes heads and block are the same
  14. alldodge

    Trim limit switch

    ^^^ Agree, it's not needed
  15. alldodge

    Boat wont start

    Don't have a wiring diagram for your motor. I do have a service bulletin for the PCM09, yours being a 2010 it may have this, need serial number to verify. The SB does list pin out
  16. alldodge

    Boat wont start

    Key turns ON no beeps but gauges turn on This means power is making it to the key and heads back to motor but ECM is not being turned ON, or as listed voltage is low so ECM will not fully power up. There are at least 3 fuses and 2 to 3 relays on top the motor. The relays are the same and...
  17. alldodge

    Boat wont start

    Measuring voltage at the starter post, what is the reading when key is turned to start? Do you get 2 beeps when key is turned to ON?
  18. alldodge

    Fuel Pump Wiring

    1. Remove the sender in pic 4 and install a brass Tee. Reinstall sender on one side of brass Tee. Other side of Tee install new oil pressure switch 2. Scott has link to switch 3. Yes, the purple wire must be mounted on the coil + side Note you must have a small post on the outside furthest...
  19. alldodge

    Fuel Pump Wiring

    Sorry Scott I retract the switch will work
  20. alldodge

    Fuel Pump Wiring

    Your pic 4 is the oil gauge sender and does not have anything to do with the fuel pump Thanks for the serial number. Your motor came with a mechanical fuel pump. The electric pump was added later. The pump was mounted on the raw water pump, item 1...
Top