Search results

  1. alldodge

    anyone have luck with aftermarket v/p fuel pump assy?

    The 1500 is a bit much my guess is this is for the entire pump assembly, 2 pumps in one unit. Will have low and high pressure pump What motor do you have?
  2. alldodge

    Audio warning system on 2003 Mercruiser 5.0

    This is where our comments come from. No clear difference as to which one is controlling the gauge
  3. alldodge

    Old gas in 2024

    Got any neighbors that may want some of it? A cheap 12V fuel pump will do it https://www.amazon.com/JDMSPEED-Universal-Heavy-Electric-Petrol/dp/B00L8IHM9K/ref=sr_1_3?keywords=12+volt+fuel+pump&qid=1697023577&sr=8-3
  4. alldodge

    Audio warning system on 2003 Mercruiser 5.0

    That's the correct part number for the gauge but still say, the gauge has nothing to do with the alarm Your thermostat housing showing 155* then it's not over heating, might just be the 2 wire temp switch
  5. alldodge

    Outboard Jet Exhaust Tube

    I don't know but most things that are press fit need a puller to unseat them
  6. alldodge

    Scan tool connector location for Mercruiser?

    It's either near the ECM or the thermostat housing. It will have a plastic cap over the DLC connector
  7. alldodge

    2007 350 mag power steering stiff

    Nut is item C in first pic The valve is inside the steering ram. Read thru the pdf attached previously
  8. alldodge

    2007 350 mag power steering stiff

    VP and Merc use similar setup and both work easy enough when everything is as it should be. If PS flid is correct then all the steering cable does is push or pull against a valve in the rear control cylinder. Make sure the flats are straight up and down and nut is tight
  9. alldodge

    What to look for before reinstalling a 4.3 engine

    Replace the bilge pump and mount both pump and float on a piece of flat stock aluminum. Bent the aluminum flat stock so mounting screws attach some where easier to get to on the stringers. This way if there is a problem later, remove screws and pull the assembly out to repair/replace
  10. alldodge

    Bravo lll shift adjustement

    As Ted mentioned, hand pump is better and I use a hand pump my self The reason you don't want much pressure is as the pressure increases the lip seal do seal tighter. So you want just a little pressure to find out if it will leak with just gear lube
  11. alldodge

    Bravo lll shift adjustement

    Yes you can pressure test the drive but note no more then 7 psi and 5 is better. Can also adjust the shift up top by hand. With motor running and cable disconnected more cable in/out to find the middle in neutral. Now it should just slide into position
  12. alldodge

    2023 IBEX

    How many HP, looks like small prop , just saying :cautious:
  13. alldodge

    Fuel water separator and fuel filter on 3L

    ^^^^ Merc says for SeaPro or Verado 3 years or 300 hours Mercruiser still list every 1 year or 100 hours My I/O was every 3 years (fresh water inland) but I also knew my gas supply source. If I was on the coast in all the humidity I would do it more often
  14. alldodge

    Fuel water separator and fuel filter on 3L

    Yes for both. The separator is both a filter and water separator. Unless you got into a place that had water in the gas or your some other way of getting water in the tank, there is most likely no water in the separator.
  15. alldodge

    How does the raw water cooling system on the 4.5L dump water when the tstat is closed?

    As I understand it The flow arrows are not 100% full time. The hose which goes from bottom of Stat to Y below is moving up even though the arrows show down. The raw water pump is pushing water to the circulating pump and circulating pump trys to push water thru block but cannot because Stat is...
  16. alldodge

    How does the raw water cooling system on the 4.5L dump water when the tstat is closed?

    Came from the service manual and another posted it, I just saved it The n path is always flowing for the most part. The crossover and thermostat are not 100% sealed off from each other, always very small passage. Also the n path does flow but is restricted a bit. Don't look at the crossover...
  17. alldodge

    Oil dipstick question for 4.5 owners, which way around?

    use low side for actual reading
  18. alldodge

    Audio warning system on 2003 Mercruiser 5.0

    It's either the gauge, sender or connections. Old sender 0 to 175 New sender 110 to 200 My first thought is old sender was fine and new is not the correct one. What was the part number? The gauge sender has no connection to the alarm and has one wire connection. The alarm switch has a two...
  19. alldodge

    LU 1655-7332 Parts Diagram?

    The link is the parts breakdown for the 850, might look in it to see if you can find what your looking for Did type in 1655-7332 and it says part not found, but does list a 1655-7333
Top