Search results

  1. dingbat

    Cannot Find VP ECM (module) for 8.1 GIL-h

    The short answer is probably not anything in the near future. Hearing things may start to come around by the end of Q4 but that's just speculation at this point. In the process of informing customers that we are upping our quoted delivery on new systems from 18 to 26 weeks. Assuming supplies...
  2. dingbat

    Cannot Find VP ECM (module) for 8.1 GIL-h

    duplicate
  3. dingbat

    Cannot Find VP ECM (module) for 8.1 GIL-h

    Electrical components are in very short supply right now. Anything that requires electrical components to build or repair is going to be affected Components that normally took 2-3 week to deliver are know quoted in months.... The CPU boards used in our equipment have gone up almost 30% and...
  4. dingbat

    Need bottom paint removal help

    Looks like bottom paint..... You can scrape or soda blast to remove but your bottom will never look good again. Faced with the same problem, I scraped the best I could and repainted with2 coats of "hard" anti-fouling paint. Was easier to keep looking good than stripping and dealing with the...
  5. dingbat

    Saltwater fishing boat help?!

    No, I have a Walkaround but the next boat will more than likely be a Center Console. The Walkaround is a great for two things, (inshore) fishing in inclement weather and they make a great family boat. Rinse the blood and guts from the cockpit after the morning fishing trip. Throw the seat...
  6. dingbat

    Saltwater fishing boat help?!

    While I’m a Grady owner and a big fan of the build quality, etc. but a 18’ boat is way too small to take a “family” out in the ocean. How much open water experience do you have?
  7. dingbat

    250 etec pair trim not working

    Would seem obvious but have you tested the batteries? Trim takes a lot of current. Replaced my trim motor this Spring. Install went easy enough but spent an hour trying to figure out why it didn’t work afterwards Had power…..just installed 2 new batteries the prior weekend. Turned out both...
  8. dingbat

    rewiring a power trim tilt

    https://forums.iboats.com/threads/3-wire-2-wire-tilt-trim.111464/
  9. dingbat

    VesselView problem - shows only RPM

    Where are you getting the power for the Bluetooth and Vessel View devices? Sounds like the network is dropping out from an under-voltage condition. Try powering the devices from a power source separate from the boat's ignition system to see if changes anything
  10. dingbat

    Battery Switch question

    Best practice is to install an ACR with a ON-Off-Both switch and be done playing “battery switch roulette” altogether. Battery wise, I divide everything into two camps. Battery 1: 1. Everything I need to run the boat to get safely home (Motor, Trim Tabs, NMEA 2000 network, Chart plotter...
  11. dingbat

    Navigation light lens

    https://www.aquasignal.com.au/product-category/port-starboard-classic/
  12. dingbat

    1996 fast trac trim tilt

    There is a 20 amp fuse in the trim circuit but it powers both relays. I would start by buzzing out the “up” side switch circuit as they are wired in series. Start with wire between the solenoid and motor switch. This segment common to both helm and motor switches
  13. dingbat

    Trailer not registered what do i do ?

    We’re from the government and we’re here to help….lol
  14. dingbat

    Pressure testing fuel tank

    As a kid right out of trade school I was as assigned to weld up a 36” x 18”x 12”, doubled walled cooling jacket for system using 1/4” steel plate. Got it all welded up, The cooling water supply was 10 gpm @ 60 psi. Hooked up a regulator and put 60 psi of air in it and went to find my boss...
  15. dingbat

    Hello can some one give me a walk through on how to clean a carb 97 15 hp force

    No glue. Holes are tapped Need to remove stud, install heli-coil and new stud
  16. dingbat

    1992 evinrude 200xp tachometer issues

    Do you a OEM manual? Looking at a manual for a 1997 and there are very specific tests to check tach operation. Don’t know if your is the same but most tests are looking for battery voltage or zero voltages between the gray and black wire at the dash without the motor running. The one 1000...
  17. dingbat

    89 Johnson get 200 no top end power

    Assume nothing…..the fact that they’ve done all this work, “everything is in spec”, and the motor still doesn’t run right speaks volumes to their diagnostic capabilities. Something doesn’t add up. Why would you need a lower crank seal on a freshly rebuilt motor? If the compression is even and...
  18. dingbat

    Will chips in my prop have an ill affect due to an imbalance?

    You’ll know if it’s alright to run
  19. dingbat

    XD100 oil

    If you want to save a couple of bucks, try XD 50 next time. The same smokeless operation at much cheaper price.
  20. dingbat

    Interpreting Hypervision Sonar Images

    Your swam of mayflies is bait fish with a few larger fish mixed in the back side. Your maybe seaweed looks to be the rhythmic rocking of the boat The lack of detail is why I don’t use “down view” or whatever name your particular mfg uses. Running CHIRP gives a very detailed, MRI type...
Top