Search results

  1. Scott06

    Mercruiser 5.7 shuts off when idling when warm

    I assume based on your other posts timing is ok ? Is the throttle cable set up to allow it to return to the idle stop screw and the screw is controlling the idle throttle plate position? There is a screw on the side of the mercarb holding a half moon linkage that connects the choke to the...
  2. Scott06

    Prop help.

    you can try a 16” Michigan vortex 4 blade is used to use one for skiiing worked great much better planning and stern lift
  3. Scott06

    Storing tubes at a boat slip

    I roll the Lilly pad up and keep it on my swim platform may not fit on yours tubes would invest in a 12 vdc inflator and pump them up each time
  4. Scott06

    What pitch should I go with?

    Unless you can get a tach to know where you are in terms of WOT rpm i would stick with the same pitch. Everyone wants more speed but unless you have enough power to swing more pitch your performance will be worse. can the local shop fix yours ?
  5. Scott06

    Mercruiser 160/165 cracked block

    Check for rot which is common in boats of this age. Possible if stored inside it is not rotten but that is the first thing to check before you put much time and money into it. Drill in bottom of transom stringers around the engine if they are ok plug as mentioned .
  6. Scott06

    How often do you change your bellows and shift seal?

    My experience has been similar 15+ years for oem merc parts. Current boat is 2004 sea ray 200 with alpha gen 2 drive. noticed this spring my exhaust bellows had torn and driveshaft bellows are showing some age So they will get changed this offseason. similar experience with impellers changed...
  7. Scott06

    3.0 pistons squeaking... doesn't sound good.

    The motor is smoked... Things dont like getting that hot. It isnt going to hurt to try and start at this point, because he is screwed already.... If 2&3 have low comrpession head gasket is probably messed up. Id make sure no water is in cyclinder before trying to start.
  8. Scott06

    140 or 160 thermostat. Does 20 degrees make a difference?

    Ive used both temps in my engines in the past. thinking on the 140 is you will crystalize less salt out of brackish/salt water with a 140 vs a 160 if raw water cooled. I suspect what you are seeing with the temp rise is either water pump impeller needs replacement, or thermostat isnt opening...
  9. Scott06

    1994 Mercruiser 5.7 timing issue- no purple/white wire

    Im pretty sure you need to advance it 6 degrees to 8 degrees before. Your crank shaft will be turning clockwise viewed from front of engine.
  10. Scott06

    2001 Glastron SX195 5.0L Volvo Penta SX Vibration when turning

    Did u check the gimbal bearing while drive was off? Unless you got water in bellows ujoints last forever… not sure with the cone clutch on your drive but makes sense it would take a turn-or two to seat the cone clutch
  11. Scott06

    1994 Mercruiser 5.7 timing issue- no purple/white wire

    Looks like you are at Two degrees btdc
  12. Scott06

    Out drive leaking.

    15 minutes to pull the drive one can do it easily, two people may take longer… shouldn't leak at all on the trailer unless water is coming over the gunnel.
  13. Scott06

    Out drive leaking.

    Yes if it sat uncovered orhad water in it yes is possible can tell much from the video need to get in there with a camera mirror etc and see exactly where water is coming in other possibilities from shift bellows and exhaust pipe
  14. Scott06

    Outdrive leaking oil

    Impeller kit isnt going to solve the gear oil leak he needs to determine which seal (s) are leaking first
  15. Scott06

    Low power under heavy load

    Yes but so could plugged carb, bad accelerator pump so test first . start with filters see whats in them …
  16. Scott06

    New prop recommendation

    Others will disagree but I am a big fan of 4 blades, on my last two boats improved holeshot stern lift and lowered planning speed. I dont have a big enough boat or go far enough to comment of fuel efficency at crusie etc.
  17. Scott06

    1975 351cu 233hp Mercruiser, riser block off plates or not?

    by block off plate do you mean the restricor gaskets between the manifold and elbow or a stainless plate between them?
  18. Scott06

    Low power under heavy load

    If the carb has a choke it is a mercarb. If it has no choke it is a TKS. Both share a common lineage from the rochester 2 jet. If it is a mercarb they have two different style accelerator pumps, you have to get the right one or order a kit that has both ( Mikes carb parts sells them) on a 3.0...
  19. Scott06

    Low power under heavy load

    Carb rebuild is likely needed make sure choke is fully opening when it is warm verify the new fuel filter u installed are still clean (that there was no residual crud in fuel system) measure fuel Pressure while running at speed with a 19” prop you should be able to get up to 4600 rpms and...
  20. Scott06

    Time it takes to prime cooling system?

    I think i depends on the engine . My old 3.0 not long , newer boat has 5.0 takes a bit longer havent timed it but long enough it always makes me worry a bit. I would think there are several gallons in the block , BBC that you have would likely take more to fill the block
Top