Search results

  1. Scott Danforth

    4.3 Mercruiser Crank, No Start

    The Delco EST has 3 wires. A purple wire that is 12 volt, a grey wire that is the tach feed and a black wire that is ground Do you have 12 volts on the purple wire when the key is on......yes or no
  2. Scott Danforth

    Building a '93 Caravelle 1750 Classic Bowrider

    Could always get the 3.0 derived LS headed motor from Blueprint Engines. It's 340hp.
  3. Scott Danforth

    Tracker Pro Deep v17 Fuel Tank Screen

    Your going to make a mess of the deck
  4. Scott Danforth

    4.3 Mercruiser Crank, No Start

    welcome aboard since you have a Delco EST, make sure you have power to the distributor (not wired to the starter at all). make sure you have +12 volts on the purple wires when the key is on. if not, check the key switch and the MOB switch since your motor cranks as normal, forget about the...
  5. Scott Danforth

    Newbie

    Welcome aboard.
  6. Scott Danforth

    Sea Ray Sundancer 1980 prop size

    If you are only getting 2200 RPM, either your tachs are reading 1/3 the RPMs they should, or your motors are shot. Prop the motor so you get to 5000 RPMs with good motors
  7. Scott Danforth

    Mercruiser 3.0L Overheated What to Look Out For?

    The 3.0 is a fork truck motor (never in a vehicle). It's a bored and stroked version of the 4-cylinder used in the 1962 Chev nova
  8. Scott Danforth

    Anyone fly Frontier Airlines? Nickel and Dime ya Airlines?

    If you take the flights without adding the frills, it's a helladeal. As soon as you buy anything, that is where the airline starts making money. The low rates are seasonal and used to entice travel. It's priced ala carte just like a new F150 on the lot. Base price ... Plus all the extras...
  9. Scott Danforth

    Anyone fly Frontier Airlines? Nickel and Dime ya Airlines?

    Flew frontier often from TPA to MKE and back. Take a small carryon that fits under the seat in front of you. This is your one personal. If you need more luggage, ship it to the hotel . Check in early to pick a seat. Dont pay for stuff you really don't need. Seriously, doesn't matter if you...
  10. Scott Danforth

    Mercruiser 3.0L Overheated What to Look Out For?

    first, the drive should be coming off every year for the annual drive service. next, re-test the compression. if your engine got to 200F, you toasted the flapper and burned up the other rubber bits in the exhaust, like the two rubber hoses. also, the lower shift cable normally runs past the...
  11. Scott Danforth

    Mercruiser 5.7 EFI Water in Oil

    looks like a parting line in the casting. however with water pooled in the bottom of the manifolds, I would file the surfaces flat, install new gaskets and run it for a run. if you still have moisture, get new manifolds.
  12. Scott Danforth

    Sea Ray Sundancer 1980 prop size

    What RPM are you getting with the 17p?
  13. Scott Danforth

    Building a '93 Caravelle 1750 Classic Bowrider

    If the gear ratio is 1.84:1 you will be about 15p. The RPMs I stated are with a 1.94:1
  14. Scott Danforth

    Building a '93 Caravelle 1750 Classic Bowrider

    You should be about 4400 RPM with the 19p with just you on board. About 4600 RPM with the 17p and about 4 on board and the 15p should redline except pulling a skier
  15. Scott Danforth

    Thinking about an upgrade for the tow vehicle

    Ted, you could always get a 550 with wrecked sheet metal from ridesafely, and swap your sheet metal / interior/ etc.....onto the 550 chassis. Just tell the Admiral in advance
  16. Scott Danforth

    Need 25 HP tiller parts

    check ebay
  17. Scott Danforth

    it has a leak

    with a dry bilge put boat in water while being armed with a good flashlight, your cell phone camera and an inspection mirror fire it up and look for water.
  18. Scott Danforth

    Are All Boats Repairable?

    my guess the prior owner used pressure treated lumber in the bunks. turn the hull upside down and put a light under it at night. you will see all the holes. can it be repaired, everything can be repaired. however will the repair be financially feasible? only you can answer
  19. Scott Danforth

    Bass boat restoration and i need a bit of help.

    based on the pictures you have shown, the hull is rotten. post pics of your stringer repair and transom repair. if the floor was rotten, the transom was rotten 10 years earlier.. boats rot from the bottom up. first to go is the bottom of the transom, then the stringer, and lastly the floor.
  20. Scott Danforth

    Water lock

    measure the SWL to elbow. should be 14+ inches
Top