Search results

  1. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Don't put 93 in it, stick with 87 Running higher octane for a motor that only requires reduces power and performance
  2. alldodge

    2005 Skeeter ZX190 Electrical Issue

    Welcome Start by checking the grounds from the Bat to the panel
  3. alldodge

    1996 Four Winns Sundowner with 5.0 Cobra engine and drive

    Welcome aboard I merged your threads, don't post multiple threads on same subject Truck and boat motors are mostly the same but next to none of the attached items are. Things like ignition, Alternator, Starter are all spark protected to keep the boat from blowing up, don't use auto parts on...
  4. alldodge

    Detailed wiring schematic for 43GL-PEFS

    Key off to KO no power to FP relay KO cranking power from key switch via Yel/Red wire thru one diode which energizes FP relay Motor starts key releases and removes power from Yel/Red ALT starts producing power and 12V comes from Green wire to second diode and energizes FP relay
  5. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    The ECM temp sensor could but the temp gauge wouldn't
  6. alldodge

    Detailed wiring schematic for 43GL-PEFS

    Search for 1 watt diode and that will be OEM size If you want get a 2 watt to handle more current Cost about a buck each or less
  7. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    If the Tach is causing the motor to miss then the ECM might think something else is happening
  8. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    It's very rare to have a coil go bad. Folks replace them all the time with no change With rpm's all over the place maybe the Tach is an issue. Disconnect the gray wire on back of Tach
  9. alldodge

    Detailed wiring schematic for 43GL-PEFS

    I don't have a pefs but this is for the GL fuel pump. In most cases the diodes are next to the relay
  10. alldodge

    Detailed wiring schematic for 43GL-PEFS

    Yes, you are correct
  11. alldodge

    New 5.7 runs and shuts off

    You can do that, but could be the Reg you have is not set at 30. Installing another Reg to control the first just means more issues, but it's your boat
  12. alldodge

    Mercruiser 383 Mag Stroker MPFI Bogs Over 3000 rpm

    Thanks even-rude for closing the issue
  13. alldodge

    New 5.7 runs and shuts off

    The Reg screen, but you said it's new and came with new Reg Partial collapsed fuel return line There is a Reg in the TB but that should have no effect on pressure because if Reg releases any pressure it has no place to go. Most TB Reg's are just to dampen fuel pump pulses Only other thing is...
  14. alldodge

    Bravo 1 low water pressure

    I'm not seeing any issue with water flow. Hope someday someone will come up with a fix to fake the sensor to the ECM
  15. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Looks like Horigan was leading you in the right direction Without checking for codes we're guessing The oil and temp switches should be able to be un-plugged. If on of them is grounding out (telling ECM to SLOW) this will show all good to ECM
  16. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Well, looks like the parts manual shows different https://www.volvopentastore.com/Marine-Gasoline-Engines-for-5-0FIPNCACE-5-0FIPNCBCE-5-0FIPNCMCE-5-0FIPNCSCE-5-0FLPNCA-5-0FLPNCB-5-0FLPNCM-5-0FLPNCS-7797220/dm/cart_id.456747459--session_id.325411975--store_id.366--view_id.765138 If you look at...
  17. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    With other running fine off same gas then look at the carb, probably clogged up a bit
  18. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Adding good gas to bad gas just makes more bad gas. If it is bad it needs to be drained and maybe used in a lawn more if it's not to terrible Take the filter off and pour contents into a clear container. The gas should be crystal clear and not smell like anything other then gas
  19. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Welcome Your motor has a ignition module but not a ECM, has carb. Don't see it going into any kind of safe mode, but may retired timing "if" it has a knock sensor. Don't see a knock sensor with the brief look over the parts My guess is you have a fuel issue, and once fuel goes bad it cannot...
  20. alldodge

    2010 350 Mag MPI bravo 3 gaurdian mode issue. 5% power

    Unsure about exhaust co but would lead me toward the exhaust O2 sensors. Being it happens at 3000 rpm try disconnecting the in-gear switch on the shift plate. Probably won't change anything but it also won't hurt anything.
Top