Search results

  1. alldodge

    Boat with engine ($500 update)

    If motor runs your good, if it doesn't then you just lost money
  2. alldodge

    Looking to buy a new Jetski

    They don't do much but do better with then without. Don't know of anyone (sure there are some) that has removed them. My guess is the Doo got slammed into a dock and broke it
  3. alldodge

    Looking to buy a new Jetski

    ford chevy kind of thing
  4. alldodge

    Air Intake Box

    I would say yes. Its part number 42969A3 (Attenuator) and if searched on there are some for sale showing all plugged. There to lessen the sound you hear. Won't hurt anything if missing so long as cowling is installed
  5. alldodge

    Looking to buy a new Jetski

    Green hulk
  6. alldodge

    Looking to buy a new Jetski

    Go with a 4 stroke, don't even thing about the 2 stroke. Had a GTI 2 stroke and now the GTX 4 stroke. Both machines run the same top speed and main reason is HP to weight. The GTI is lighter then the GTX, so GTX needs more power. The non-super charged GTX 4-Tech is next to bullet proof...
  7. alldodge

    Timing my 1987 Mercruiser 3.0 with newer EST ignition

    The 3.0 and EST is a mix bag and all are based on serial number. 1 BTDC - Serial number break: 0L096999 and below 1 ATDC - Serial number break: 0L097000 - 0L0340999 2 ATDC - Serial number break: 0L341000 and above I might go with 1 BTDC because this was also used during initial roll out, then...
  8. alldodge

    Fuel pressure gauge

    That's normal, a mechanical diaphragm pump will pulse like that or even a bit more. An electric can also see a bit of that
  9. alldodge

    Fuel pressure gauge

    Manual 2 for Ford 302 list fuel pressure as 3-6 psi
  10. alldodge

    Magnum or No?

    Others may be able to provide better info, but manual list all "magnum'" with cubic inches (so 454, 350, etc). Motors with 7.4, 5.7 etc are not
  11. alldodge

    Battery question

    12.4V is 80% charged Look for corrosion on the ground cable connection
  12. alldodge

    Fuel pressure gauge

    Maybe, depends on what motor? If its a Merc carb motor and gauge is accurate then all good
  13. alldodge

    Re-wire kit

    Wiring can be found in the manuals based on what motor. Can get custom wiring harness for motor and boat side. May be able to find a ready made harness but being that old it may be hard to find new, most likely used The trim and K planes will be easy enough
  14. alldodge

    TRS sterndrive maintenance

    TR and TRS are in manual 5 Parts https://www.mercruiserparts.com/all-trs-drives Find most knowledge on the drives at OSO
  15. alldodge

    Fasteners thru hull of thin hull fiberglass boat below waterline

    Need to get to dry wood, without getting to dry wood you'll only be doing a repair again later. Should have been drilled larger hole, fill with epoxy then drill for smaller screw. That or epoxy a piece of plastic/Starboard or other and use it to mount
  16. alldodge

    trim relay wire diagram

    Are you talking about this relay?
  17. alldodge

    Can I plug the trim lines on a T/T unit and still use the tilt

    No
  18. alldodge

    Transom bent on my 14' Landau

    2 by's will warp, suggest using 2 layers of 3/4 plywood and glass them together. Or 2 layers of starboard marine board
  19. alldodge

    Type of sealant to use

    Suggest 3M 4000
  20. alldodge

    Mercruiser 140 1976 Down trim limit.

    Many times the limit stops working, so if there was a limit with down and the drive was up, that could be worst IMO
Top