Search results

  1. alldodge

    VP 5.0 GXi-G spark plug corrosion

    The front right (starboard side) is cylinder #2
  2. alldodge

    5.0 GXi-G fuel pressure regulator

    For the most part, could be. Spec list 50-60 psi and don't know how accurate your gauge is. It it is accurate then its a tad high, but won't be an issue if it lowers to 60 once started
  3. alldodge

    2001 Vista 268 Battery Switch

    The diagram doesn't show the windless, it was an option but not shown You said the end of the wire in mp pic listed as going to the windless is cut? If it is it does make since why it would be cut unless the windless was removed, is it still there?
  4. alldodge

    2001 Vista 268 Battery Switch

    That wire should go go directly to the windless or windless control box. Most cases the control box (relays) will be close to the windless
  5. alldodge

    2001 Vista 268 Battery Switch

    Your correct, but I would suggest connect all large Bat grounds direct to engine block. Should have a stud on the rear of bell housing to connect. Then connect smaller 10AWG wire from block up to where they connect now. The way it is now will work Don't know which motor you have but suggest a...
  6. alldodge

    2001 Vista 268 Battery Switch

    Negative sides on both Bats get connected together along with any other grounds
  7. alldodge

    Installing a new asphalt driveway

    That would be yes, Da ;)
  8. alldodge

    What would happen if an engine died on plane?

    Alpha may ratchet but Bravo's will not
  9. alldodge

    What would happen if an engine died on plane?

    With gas it would slow down coughing sort of, settle down and water would slap against the stern but that would be it. It would happen faster if lets say the kill switch was pulled, but same thing. Only worry is if anyone went flying forward with it stopping fast
  10. alldodge

    power trim and tilt

    That's not a trim/tilt unit, it's a linear actuator ith home made brackets. There not designed to get wet. Search "linear actuator" and you will find them
  11. alldodge

    Trailer surge brakes

    I ran a separate wire to the lock out so it could be engaged from the dash switch
  12. alldodge

    Trailer surge brakes

    Nice and make sure to put something around the line where it exits to keep the frame from cutting the line over time
  13. alldodge

    Will self leveling trim tabs cure slow speed wandering ?

    No
  14. alldodge

    Simple Floor Ideas?

    4 pound foam, the type you pour in and it expands
  15. alldodge

    Dean's List gets another motor

    This motor does not want to be built Installed heads and tightened bolts down in 4 passes. FelPro said wait 10 minutes and loosen each bolt one at at time and retighten to spec in one pass. Never done this before but ok since FelPro stated. Well one of the block threads said NO and heard a...
  16. alldodge

    Simple Floor Ideas?

    No expert; but why not 1/2 CDX plywood and coat both sides with fiberglass cloth and resin
  17. alldodge

    mercury vesselview

    Hey @tpenfield OP says it can be changed with diacom, you know how?
  18. alldodge

    Cannot use trim assist 2022 yamaha

    Sorry, I have nothing, not even able to find how to install
  19. alldodge

    Cannot use trim assist 2022 yamaha

    Have a look at this vid and see if it helps
  20. alldodge

    mercury vesselview

    If the motor is connected to the wrong data link cable then its not going to work
Top