Search results

  1. R

    Power trim

    Not anything that was made by the Johnson folks.----No idea how or where to get that fixed or if parts are available.
  2. R

    Power trim

    Model # of your motor ?---Or picture of this unit ?
  3. R

    Merc 650 water tube/ exhaust gasket questions?

    deleted
  4. R

    1984 starcraft islander

    ??----Use a meter.----The + cable goes to the solenoid.----The - cable goes to the block.
  5. R

    1986 Johnson 9.9

    The pump is not self priming.-----It does not pump / move air very well.---- I would inspect impeller .
  6. R

    Tilt trim motor working but engine won’t move

    Water in the trim / tilt and in freezing conditions ??
  7. R

    Evinrude 25 Lean sneeze

    Perhaps post video of the motor running and sneezing.-----This should not be hard to figure out.----But that is my opinion and others may disagree.
  8. R

    94 Johnson 150 Fast strike falls flat over 3200 rpm

    rja-----Took the high speed jets ( orifice plugs ) out of the old bowls and installed in the new bowls ?------
  9. R

    Evinrude 25 Lean sneeze

    Maybe a defective lower crankshaft seal.
  10. R

    1993 Evinrude 60hp

    If it was pumping oil with motor shut off it sounds like , and could only be the vent plugged on the oil tank.-----VRO pumps are NOT electric.----Vro pump operate with crankcase PRESSURE pulses when engine is turning.
  11. R

    Evinrude 25 Lean sneeze

    Adjust the rod on the side of the block so that carburetor opens a little later.----Remove slow speed mixture needle and post picture of the tip.-----In my opinion this should be an easy fix.
  12. R

    Boat with engine ($500 update)

    Fact----When a shop works on a $100 motor for 3 hrs it adds up to a $500 invoice.------Owner will howl and call them various names.------When they work on a $50,000 boat for 3 hrs and show a $500 invoice the owner will say " thank you very much "-----But I agree for some folks an older motor...
  13. R

    We did a thing...

    Friend-----Lock the wife in the trunk of the car for 15 minutes.------Lock the pup in the trunk for 15 minutes.-----When you open up the trunk you will know who is your friend !
  14. R

    adding tilt and trim to Johnson

    Your information is totally wrong !-----Inside the transom brackets was available in 1978 for 3 cylinder 70 HP.-----Later ( 1988 ) labelled as 60 HP at the propshaft.-----Lots of used ones are available depending on your location.
  15. R

    1993 Evinrude 60hp

    Clearly stated in post #1 that VRO is not used.---Pulse limiter ( flow fuse ) for VRO has been removed as well.-----Running with a simple pump on this motor I assume.
  16. R

    We did a thing...

    Tomorrow will be 1 year since a stray cat showed up in our house.----Adopted me after the vet bills ( ouch ) to deal with an injury.-----I do feel good about it all.
  17. R

    replacement carburetor for 89 Suzuki DT15c

    browns point marine could help ??
  18. R

    Prop spin

    Check gear oil for metal bits.---Pinion gear teeth could be stripped.------Those lower units are NOT robust in my opinion.-----But 35 degree rotation is in fact normal.
  19. R

    70hp evinrude pitch size advice

    If boat goes LEFT, you turn trim tab to the LEFT
  20. R

    Ethanol free gas age vs carb

    Wee piece of wire and push them out from other side.
Top