Search results

  1. R

    Transom adaptor from 15" to 20"?

    Some will argue.-----My approach would be to put electric start on the Evinrude 35 HP.
  2. R

    1977 75hp evinrude 3 cyl

    What is your motor doing / not doing.----Timing does not go out of adjustment on these.
  3. R

    1958 evinrude lark 35 hp 35514 water pump

    Put hammers away and stop yanking.-----Remove 2 wee covers on the side and REMOVE one bolts from shift rod connecter.-----Do a complete evaluation of this motor BEFORE spending any beer tokens.-----Be silly to have a $200 water pump kit for a motor that is JUNK in my opinion.
  4. R

    Rebuilding gear case, random unknown washer

    Your wife or neighbor threw it in there just for fun.-----How did you determine shims for the pinion gear ??----Did you buy new factory gears for this motor ?
  5. R

    1958 evinrude lark 35 hp 35514 water pump

    You have to take the rear cover off !!----There is a hidden bolt comes down from above.
  6. R

    1958 evinrude lark 35 hp 35514 water pump

    That pump will have 2 tubes I think.-----impeller is 777213, ---plate 312613,----housing is 378348 ------Some will argue.-----My approach would be to inspect the parts FIRST as you may only need an impeller.------Complete kit is available ( often not listed for 58 models ) and may not fit in...
  7. R

    1974 Evinrude 25hp wont run.

    So you miss-understood the purpose of the driver coil.----Once again I am blunt.----If you are not sure how things work then the trouble shooting / repair may take a long time.-----We are now at post #151 and counting.----
  8. R

    1974 Evinrude 25hp wont run.

    The driver coil is to produce voltage for the ignition coils to step up to 30.000 volts at the plugs..-----A battery charging coil would be in addition to that driver coil , with yellow wires going to a rectifier.----Do you have a rectifier ??----Have you tested the driver coil ?----With 2 sets...
  9. R

    Evinrude 115 Won't Idle?

    Trouble shooting starts with a compression test.----Post your numbers here.----You did install a new impeller ?----You have verified that oil injection is working properly?
  10. R

    1958 evinrude lark 35 hp 35514 water pump

    I believe there are 2 different models of 35 HP with different water pumps.----Are there 2 water tubes on the pump or just 1 ?------Post pictures of this motor.---And is the model # correct ?
  11. R

    Gearcase

    Just 100 inch lbs.
  12. R

    Identifying old SS OMC prop size

    They were available in 15 , 17 ,19 ,21 and 23"pitch.----And I am sure they are marked with or a part number.
  13. R

    1974 Evinrude 25hp wont run.

    The motor needs crankcase compression to operate these simple pumps.----It appears you are totally confused by ignition coils under the flywheel and the driver coil under the flywheel.---And is there one set of magnets or 2 Inside the flywheel ??---n brvgffffr
  14. R

    Gearcase

    Pressure test the gearcase to find the leak if there is one.
  15. R

    1975 meecury 65hp outboard motor

    Some of these may have had a water cooled fuel pump.----Perhaps that was disconnected / bypassed ?
  16. R

    Evinrude 60Hp - wont stay running, help!

    Where did you get the ignition switch and what part # was it ??
  17. R

    1974 Evinrude 25hp wont run.

    The pumps operate on crankcase PRESSURE and most pumps have no trouble pulling fuel up 4 feet.-----Fix any and all leaks including inside the tank.
  18. R

    Why can’t I find information on my Mercury outboard using my S/N????

    It might be a 73 model.----Your location in Canada and what dealers are failing to help you ??----Post picture of the cowling.
  19. R

    1973 johnson 25hp 25R73A

    Rust on the reed valves would make me do a total tear down.------Opinions do vary on this approach !
  20. R

    Why is my carb oxidizing????

    The air can be quite corrosive in and around farm buildings.
Top