Search results

  1. alldodge

    Carb or worse?

    Bit late, but push rods and lifters should be kept in original position. Probably still be ok, but always best to keep them in order When installing rocker arms, the valve must be fully closed. Once closed zero lash is determined and then 3/4 of a turn more Zero lash is found by holding the...
  2. alldodge

    Mercruiser 5.0 MPI Bravo 3 overheat 5 minutes after starting it up.

    Yes, post 9
  3. alldodge

    Chris Craft Volvo Penta 4.3 Ignition does not turn engine over

    Power comes from motor to ignition 20 amp fuse Fuse to key switch red/purple Key purple to kill switch Kill switch to gouges and back to the motor Having 12v on both sides of kill switch and no gouges means broken wire between the two. Hand trace the purple
  4. alldodge

    Need More Bling

    Ahhh no to both
  5. alldodge

    Carb or worse?

    Get a straight edge and check flatness. If both are flat then all it will cost ya if it fails is another head gasket
  6. alldodge

    5.0 TBI low fuel pressure after running for 10 to 15 minutes

    The coolers are to help prevent vapor lock. That's not your issue and the motor would overheat if there wasn't enough flow. Only way I know to measure pressure on TBI is with the Merc tee fitting
  7. alldodge

    5.0 TBI low fuel pressure after running for 10 to 15 minutes

    Your hand pump might be masking the real issue. It might be a collapsed fuel line, but then again it may be the regulator (item 15). Need to check fuel pressure 30 psi. Could be its low to begin with and just gets to low to run later https://www.mercruiserparts.com/bam/subassembly/31846/4856/90
  8. alldodge

    Mercruiser 3.0 blowed a spark plug

    Need a carb rebuild
  9. alldodge

    Carb or worse?

    Have a valve job done on the head. The machine shop will check for flatness and cracks. Check the block for flatness using a metal straight edge, like a framing square or other. If the head or block isn't cranked, then water came in through the head gasket
  10. alldodge

    Changed Bellows still have water

    Place the boat in the water and use the camera it and around to see where water comes in at
  11. alldodge

    Changed Bellows still have water

    I'm sure you don't want to hear this, but it comes down to figuring out where the water is coming in. Don't know how fast its coming in, but use your phone camera and get it where your head doesn't fit and see if you can find out
  12. alldodge

    Mercruiser 3.0 MPI ignition timing.

    Looking thru Brunswick. the only manual is the operations manual which is free. Its free because it has nothing in it to help. Also states timing is non-adjustable. Looking at Merc site it list operations, parts and brochures, but no service manual
  13. alldodge

    Mercruiser 3.0 MPI ignition timing.

    Agree, only issue is the ECM can only adjust so far. With the V6 and V8 the distributor has a install method to get it real close. Without knowing the install or setup, anything is possible
  14. alldodge

    Mercruiser 3.0 MPI ignition timing.

    Hey @Fun Times have any idea? States right on the cover, its non-adjustable
  15. alldodge

    Mercruiser 3.0 MPI ignition timing.

    Being a 3.0 MPI it should be a CAT motor. This would mean it has a Delco EST distributor. A serial number would verify The hard part is I don't know of anyone which has the manual for the motor. Being an EST it should list what timing is set at on the cover. IS there something there?
  16. alldodge

    Need More Bling

    Got a new truck last month (already put 4500 miles on it :poop:) but just not liking all the black. Long story short, dealer used stock photos instead of actual photos. The short of it, I do like the way it rides but not all the black out, its a Night Edition. Has 20 inch wheels, and I...
  17. alldodge

    Volvo Penta 4.3 GL-G Engine Vibration, Running Rich after New Distributor

    Sounds like carb is flooding
  18. alldodge

    Volvo 2005, 5.7 osi wont start

    Turn key ON and check for 12V on the main power relay purple wire. If power is there check for 12V on the pink/white wire on the coil and fuel injectors
  19. alldodge

    Chris Craft Volvo Penta 4.3 Ignition does not turn engine over

    Most kill switches turn power off to the gauges and motor, but does not kill power to the start relay. In short, motor will crank, just not start. The start circuit goes from the key yellow/red wire, thru the neutral safety switch, to the start relay. Turn key to start and move the throttle...
  20. alldodge

    Mercruiser 3.0 blowed a spark plug

    What did the other spark plugs look like? Are you getting spark? Do you have fuel?
Top