Search results

  1. alldodge

    L6 Mercruiser simplified engine wiring

    Don't know your luck with one wires, but I bought a 100 amp one and used it half a season, then removed. It still sitting on the shelf from boiling my bats
  2. alldodge

    L6 Mercruiser simplified engine wiring

    ALT wire only needs to be orange if you want to keep the colors correct. Red is fine The shift interrupt are black. When shifting the switch grounds the - side of the coil to cause a mis fire
  3. alldodge

    L6 Mercruiser simplified engine wiring

    OK, 1 wire, then your good and don't need the others
  4. alldodge

    L6 Mercruiser simplified engine wiring

    So you have one wire ALT? Post pic
  5. alldodge

    L6 Mercruiser simplified engine wiring

    Just noticed you removed the purple on the ALT and added a wire to the bat What you have will work but will need to put the purple wire back to the ALT. In fact the ALT needs 4 wires total Orange - output to bat Purple - Excite which turns the ALT on from the key Red/purple - 12V full time...
  6. alldodge

    Bravo 2 outdrive not engaging when in gear

    What, no oil slick drive again :unsure: :ROFLMAO:
  7. alldodge

    L6 Mercruiser simplified engine wiring

    The wiring isn't correct in design nor color for AYBC The red from the run circuit is connected correctly, but uses a white resistance wire. This in it self is ok, but should be purple or go to a ballast resistor, unless a resistance wire is used There is no ALT output connection back to the +...
  8. alldodge

    Universal M25 Oil Pressure Switch

    Unless there is a gauge (don't think so) then guess its the man removal
  9. alldodge

    Carver 3007 1981 Engine sea cocks

    In most cases when discussing specific things on a boat which may be different, its best to post a pic In most cases the seacock is a ball type valve. This means the handle should be inline with the hose when Open and cross ways when Closed. They should always be open when running the motors...
  10. alldodge

    Universal M25 Oil Pressure Switch

    While most use a wrench, you can also use a socket. Have you tried a socket? Not real familure with the motor, but if it has a oil pressure gauge then the switch could be Tee'd with the sender
  11. alldodge

    Milky madness

    40 watt bulb will keep it plenty toasty If you really want to just keep it warm for the winter and there is no power outage just get the proper heater and go...
  12. alldodge

    Impeller for 5.0 GL PEFS

    Thanks Bruce, can you clarify the 1348 is impeller and O ring, where the 1346 is the O ring and 3 paper gaskets, right? https://www.amazon.com/Volvo-Penta-Impeller-21951346-3862281/dp/B00KQ8DBKC
  13. alldodge

    Bravo 2 outdrive not engaging when in gear

    Oh yes, forgot about that little thing But if that coupling is attached your not going to be able to turn the prop
  14. alldodge

    Bravo 2 outdrive not engaging when in gear

    All shifting is done in the top half, its just gears in the lower. Check to see if its in throttle only. Otherwise I would pull the rear cap off to see if the shift mech is moving when shifted
  15. alldodge

    Bravo 2 outdrive not engaging when in gear

    As the Bravo is installed the cable needs to be latched into the keeper before moving it the rest of the way into the bell housing. Grab the latch with pliers to pull it out if its inside. Latch cable and push in
  16. alldodge

    Impeller for 5.0 GL PEFS

    I'm finding kit number 21951346 Used this site to look it up https://www.volvopentashop.com/epc/en-US
  17. alldodge

    Impeller for 5.0 GL PEFS

    What is the motor serial number?
  18. alldodge

    L6 Mercruiser simplified engine wiring

    This is the helm wiring using the standard 10 pin harness Note all gauges tie into the Purple
  19. alldodge

    L6 Mercruiser simplified engine wiring

    The ALT should have 4 connections Ground - Black Output - Orange Sense - Red/purple from 50 amp breaker Excite - Purple from key This is a 3.0 using EST distributor but other then that the wiring will be the same
  20. alldodge

    2000 Yamaha GP1200R- Fuel/Air Issue?

    Not familiar with Yams, but they all operate about the same Blow the lines out with air but be careful with not to much air. Might be a screen in the tank or other. You have Mikuni carbs and pumps. The pump is a small rectangle mounted on the motor. It uses exhaust gases to work the pump...
Top