Search results

  1. alldodge

    Outdrive wont go back on!!!!!!

    It goes in and out with 2 fingers and drive will not go on, I would say there is something wrong with your alignment tool If different spacers are needed, then need to look close at the rear mounts, they may need replacing Was the gimbal bearing replaced, and if so are you centering it...
  2. alldodge

    Not Turning Over, Low Compression, Mercruiser 3.0

    How to start
  3. alldodge

    SC1000 Smartcraft gauge can't read digital readout

    Boat yard installed motor and gauges, so why doesn't the boat yard fix the issue, or have you asked? If the tank is not connected to the CAN network then it doesn't know. If it is connected, then once programed, and gass is added, it will calculate how much is left based on the level Is your...
  4. alldodge

    2002 Tahoe 202 - Mercruiser 5.0 MPI fuel pump not priming

    The MPR sends power to 2 other fuse, one of which is for the FPR. When MPR connects there should be 12V on pin 85 and 30 (not 86) on FPR along with connection to the IAC. So there is a bad connection or MPR coluod be the issue
  5. alldodge

    Looking for scamatics

    This is about the only one I have for OMC
  6. alldodge

    4.3L Mercruiser Won't Start

    Dang, let me go dunk my hat in the creek. A 2011, not a 2001 but 2011 with a TKS, I never would have thought that OK, I'll go with it but TB ignition is not longer available So you used the TB% troubleshooter?
  7. alldodge

    4.3L Mercruiser Won't Start

    Flat cap is what most call carp cap because they are always going bad, but are the HVS distributor and look like this CAT's mean catalytic converter exhaust system
  8. alldodge

    mercruiser 5.7 hard start fuel pump/oil pressure switch?

    I'm thinking the electric fuel pump was added to the motor later. In 1995 the SBC had a mechanical fuel pump unless it had TBI. It needs a 3 prong switch and would be wired like this...
  9. alldodge

    mercruiser 5.7 hard start fuel pump/oil pressure switch?

    The starter powers the fuel pump (Purple/Yellow) when the motor is cranking. Once the motor starts and oil pressure builds, then the switch sends power to the pump Check the purple/yellow wire coming from the starter
  10. alldodge

    Alt Gauge Help

    The voltmeter does connect to the purple wire but it would connect to it at the helm, not at the motor. Each gauge will be daisy chained to the purple coming from the key switch
  11. alldodge

    Volvo penta 7.4gi loss of top speed perhaps tied to slight thermostat overheating?

    Pressures
  12. alldodge

    5.0GL-H have fuel at carb, but won't start when hot out.

    Your unable to edit a thread after so many hours. To give others insight to previous comments https://forums.iboats.com/forum/engine-repair-and-maintenance/volvo-penta-i-o-inboard-gas-engines-outdrives/10910139-5-0gl-cut-out-now-wont-start With the GL being a carb motor, there should be no...
  13. alldodge

    2002 Tahoe 202 - Mercruiser 5.0 MPI fuel pump not priming

    Need a voltmeter and measure at the purple wire on the key. There should be 12V when key is turned to ON. If there is 12V, then check one of the other purple wires connected to one of the gauges. If 12V is there, check for 12V on pin D of the DLC connector 4 pin connector with a cap If 12V...
  14. alldodge

    1973 Mercruiser in-line 6 water temp gauge issue

    The gauge would have 3 wires. Do check is there is a bad ground White - 12V Green - Sender Black - Ground (not shown on wiring diagram) The light is turned ON normally when ignition is turned ON
  15. alldodge

    1991 4.3 exhaust cooling holes size?

    That should work but I would go with these to make winterization easier Merc 22-862210A01 Sierra 18-4224 Could even go to local hardware store an find a straight or 90
  16. alldodge

    Trim motor clicks

    OK, use this one If all else fails you can change from 1 to 2 solenoids if needed later
  17. alldodge

    Trim Switch Question

    Yes, that helps, didn't know if it was an electrical issue or a hydraulic issue. Being electrical issue, I would guess its either corrosion or bad switch. Need a multimeter and check voltages. Measure voltages on the small terminals at the pump relays. Check for power on the small Blue/White...
  18. alldodge

    Raw water pump not sucking water

    Might be bravoits
  19. alldodge

    Trim motor clicks

    Being a 1979 you should have 2 solenoids. If it turns out you have only one I'll post the other
  20. alldodge

    Need Help on 5.8fsi Couple of Issues

    Did like those 340's :D Need to get the pressure up, with pressure that low your probably running lean and it can burn a piston Firing order
Top