Search results

  1. alldodge

    oil type/ firring order

    Visual
  2. alldodge

    Steering cable nut - how to remove

    There is a slot on the tube where a wrench goes (top right). When reinstalling cable make sure flats are up/down as shown
  3. alldodge

    Wiring a Battery Switch for Trolling Motor?

    The issue with jumper cables would be the same as placing the batteries in parallel. The issue is you don't want to do this after one has gotten low because it will drain the other. Now if they are paralleled at the beginning, then they both are drained at the same time. You only have 12V so...
  4. alldodge

    3.0 Mercruiser idling problem when cold

    Adjustments
  5. alldodge

    Exhaust manifold/riser

    Always good to know the rest of the story If there is sufficient water coming in from the hose, and water coming coming out the exhaust I would look at the thermostat housing and are the check balls in place? Then is the circulating water pump working, vane not loose or broken This is V8 but...
  6. alldodge

    No power to dash/ignition? 1988 Sunbird

    You need to get a voltmeter and trace the wiring. Won't be able to upload pics until you have a few more post This is the OMC wiring and its for a V8 but will work for yours also
  7. alldodge

    Air actuator removal

    Suggest installing one of these at the pump, so it can be drained easy, unless its easy to remove hoses
  8. alldodge

    Engine will not crank or start....

    Turn key to start and grab the shifter and move it slightly fwd/rev to see if it needs adjusting/replacing. If no luck, use a voltmeter and place it on the yel/red wire on the key switch and see if you get 12V when the key is turned to start. If 12V is found, check if 12V is found on the Small...
  9. alldodge

    Wiring question: Slave solenoid to Ignition coil

    PO might have been using a Merc diagram and may have also had issue with ESA. Just guessing and its hard to say why folks do things. I would be inclined to put it back to original
  10. alldodge

    NEED WIRING DIAGRAM! Only 6 volts to fuel pump

    This would be the carb fuel pump wiring
  11. alldodge

    Keep Blowing Fuses

    Nothing is wrong, its as it should be. 12V connects to gauge, the pink wire feeding sender does not have full voltage
  12. alldodge

    Trim Tilt works on motor but not control?

    If its only the up function then its the trim limit switch or bad connection If its up and down then there is a bad connection or no connection
  13. alldodge

    Shore power issue

    Remember there is only 1 hot, the other is common The Y's are normally designed to take 2 - 30's and make them 1 - 30, and not the reverse. Look at the connectors and are they all 30 - 120V and not something else?
  14. alldodge

    Mercruiser audible alarm

    Hope I didn't miss something
  15. alldodge

    4.3 mercruiser sputtering and shutting down after running over an hr

    Can make one from parts at the auto store (plastic Tee, rubber hose, fittings), but the Merc part number for the Tee is 91-18078
  16. alldodge

    Carb passage blocked? QUADRAJET MCM 228

    Those ports do not go straight thru, they bend/angle https://www.hotrodders.com/forum/quadrajet-running-rich-no-matter-what-jet-size-used-451098.html
  17. alldodge

    Mercruiser audible alarm

    Not sure I can make a post as before because I need to change some info on it, but will work on it
  18. alldodge

    Troubleshoot stiff power steering

    Not being in the water, and not sure but I think your ram is the issue. It should be real easy both directions and not being in the water even more so. Its hard right so the valve in the ram would be my guess as the issue. Might be the valve is gummed up
  19. alldodge

    Mercruiser audible alarm

    Hope this make it a bit more clear
  20. alldodge

    Fuel Pump 20-amp fuse blowing

    May not be totally up to date but should help
Top