I have not, but it must be true because the police have said it is, then that is the way it is.
Suggest contacting NJ DMV or who ever does boat/trailer licensing and ask for the regulation. The reg should state what is expected/needed
Thinking the trailer is like a long Tee, maybe it just...
If the transom plate is at an angle and not parallel within 1/8 (2mm) to outer surfaces, this will keep it from aligning within spec.
When installing motor, was the rear bolts installed snug, motor lifted up off front mounts just bearly hanging from the thermostat housing. Then lower front...
Agree check power at the coil in run
Also disconnect the shift interrupter switch just to rule it out if it is casing any problems. The switch should not be the issue, but disconnect it just to remove a piece out of the equation
If you have 2 seals, I would recommend using the new style seals which are a double seal, part numbers:
1 each Small inner seal 26-8M0033407 (replaces 2 each lip seals)
1 each Large outer seal 26-861694 (replaces 2 each lip seals)
Dimensions 3 - 3/8 OD, 2 - 1/2 ID, 13/16 wide
You...
In general accelerator pump and choke plate arms are adjusted by bending the arms/rods. Things like tangs are bent for certain idle stops and/or floats
If the VP is wired like the Merc (probably is) the pink, pink/white are ignition power and injectors are batch fired (4 at a time). Ground is applied by PCM
Could be VP uses 2 different fused feed lines to power each side. Look forward to MUC input
Merc type which uses all pink/white
None of your diagrams will work, only one that can be used is on the left and it will only work to start the motor and run boat electronics.
This setup will do what you want without a switch, but keep in mind it will drain both bats when trolling. If both are drained to far, then there is a...
It sounds like rod bearing until the rpms come up, then when the noise should get worst it starts going away. Post a vid of the motor just idling.
Check the firing order 1-3-7-2-6-5-4-8
Grand kids are all great, I have 6, but yesterday got my first great grand baby. Her name is Genesis
Told my friend I'm now great at something :D and he replied ahhh no your not :(, might need to rethink my friends list
Structurally they look fine, but stretched out that far kind of makes me think the springs are at there limits. Don't see them breaking but the boat is kind of heavy for them.
Those are open eye
There is a small hole in the center of the drive and it uses an o-ring to seal next to the exhaust port. This pic is showing the differences in years on the housing, but just note where the o-ring and oil port is.
If its not leaking at the prop shafts my next thought would be the shift shaft...
The water heater on my Formula was connected the same way, just the flush doesn't look like it would work very well, but just my opinion
Many use a Tee connection on the intake hose to the pump and switch then start the motor.
For others to see a few pics easier
