Search results

  1. alldodge

    3.0 merc died and now there is no spark

    Not good, orange is not enough to pass thru the wires and have enough left over to spark the plug gap
  2. alldodge

    Mercruiser injector harness plug sequence

    The motor uses batch firing
  3. alldodge

    Mercruiser Power Trim Pump

    The one solenoid uses a different one then the one your showing Might be a lot easier to just rewire for 2 Here is the one solenoid
  4. alldodge

    Mercruiser Power Trim Pump

    I'm unable to understand where all the wires go. The pump is the older model Prestolite pump but it still works the same. Not knowing what year your boat is I would say it should be wired as shown with 2 solenoids, not just one
  5. alldodge

    Bravo lower shift cable adjustment tool specs

    In most all cases you don't need the anchor adjustment tool anymore, but its just a 1/4 plate with a slot in it to hold neutral position. The tool was used before the factory started adjusting the length and penned the barrel nut fixed. You also don't need core wire, you use a piece of the...
  6. alldodge

    2000 Bravo Three lower unit detachment

    Being you have a 2000 drive, there is 7 total fasteners, 3 nuts on each side and one bolt on the tail.
  7. alldodge

    Mercruiser power assist issue

    Check your install method. Need to make sure the slots on the steering ram are vertical (note figure "d" on the right) before the nut is tightened
  8. alldodge

    How to Refill Antifreeze 5.7Gi

    In my pic above I mistakenly said the clear box on the front left as a over flow container, its the out drive lube bottle. Your pic is like the one above and also my dump truck
  9. alldodge

    How to Refill Antifreeze 5.7Gi

    There are some that are made that use a hose to a separate tank with the cap on it. Many of the BB use this method, but they just get filled at the tank and it flows into the HX. My dump truck also has similar kind of set up. In the pic, the over flow container is on top left, next to it is...
  10. alldodge

    Looking for 1990 3.0 exhaust manifold

    It is a unicorn, but just maybe Lou's will work, or maybe even a different one if thought about it just a little more. Yours in one of a kind, I cannot even find it on the web with a part number. But if we look at what is actually needed, only the outside area needs to seal. The ports are in...
  11. alldodge

    2002 mercruiser 3.0 issues starting

    Slave relay on the motor item 17 part number 89-96158T, old part number is 89-96054T which also works just fine https://www.mercruiserparts.com/bam/.../30914/1604/70 The relay sends main power to the starter solenoid so the power to from the key doesn't have to go so far
  12. alldodge

    Credit Card and ACH transfers

    This is Blah blah stuff I have a vacation rental and need to be able to accept CC and direct ACH transfers. Have a paypal account but just had my first, and they sent the funds as Goods. Sending as goods it put the funds on a 21 day hold. I called paypal and they changed to services, but then...
  13. alldodge

    5.7GXI-A won’t shut down with key (it’s not dieseling, it just runs) Need Guidance!

    VP used the mando ALT for the A and note the jumper. You would need to get yours rebuilt or replaced. Before doing either, do check how much the ALT is putting out when running, it should be close to 14.5V Later models they changed the wiring so this won't happen.
  14. alldodge

    Water Circulation Problem - 5.7 raw water cooled

    Since you have riser extensions, I think one of your gaskets are wrong, or in wrong order. Do check both sides to make sure they are both set up as in the pic
  15. alldodge

    technical question about camshaft replacement 454 merc gen iv

    Should only be 2 marks
  16. alldodge

    Electric fuel pump and placement

    Between carb and filter. Placing it there helps protect the pump from crud No :nono: primer bulbs are only used on outboards. They can be used on I/O's and other for testing purposes only
  17. alldodge

    CAT Motors

    Only know of a few on forums that may have the knowledge to answer to questions, but sure like all thoughts just for discussions. We have been seeing water pressure issues even prior to the CAT motors, and now I'm seeing things getting even worst. Have seen a few threads talking about issues...
  18. alldodge

    Losing power at fuel pump

    Don't have a F but have up to D model but with not power to the fuse, then either the fuse is blown or the Red feeding the fuses is disconnected
  19. alldodge

    wiring problem 485 mercruiser

    Really don't like one wires but that was not your issue The below schematic is for the 485 with an amp meter. Note there are 2 wires going to the + side of the coil. The purple comes from the starter solenoid which powers the coil when starting. Once started and the key is released to RUN...
  20. alldodge

    Battery wired correctly?

    From what I "think" your saying how its wired I would say no, that is not correct Grounds from both bats should connect to the engine block together with large enough size cables. Another wire sould go from the engine block to the Ground buss bar The battery switch should have the positive...
Top