Search results

  1. Mercury-Racing-1650.gif

    Mercury-Racing-1650.gif

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  2. ScottsBoat.png

    ScottsBoat.png

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  3. signature-image.png

    signature-image.png

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  4. boat on fire.jpg

    boat on fire.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  5. boat-owner.jpg

    boat-owner.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  6. dumpster-fire.jpg

    dumpster-fire.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  7. fish-pond.jpg

    fish-pond.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  8. mini-boat.jpg

    mini-boat.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  9. profile-pic.jpg

    profile-pic.jpg

    • Scott Danforth
    • Media item
    • Comments: 0
    • Album: 1988-Rogue
  10. Scott Danforth

    Transplanted a 5.7L TBI, shift plate question....

    swap your drive from an alpha to either a VP drive or a bravo (both have cone clutches and don't use a shift interrupt)
  11. Scott Danforth

    How to identify Mercruiser 3.0 starter model

    unbolt yours or stick your head under there to see if they are staggered or straight, order PMGR (will be listed from 3.0 to 8.2 liter)
  12. Scott Danforth

    How to identify Mercruiser 3.0 starter model

    there are 4 kinds of GM starters. a direct drive and a PMGR. each one of those comes in staggered bolt pattern (168 tooth flywheel) or straight bolt pattern (153 tooth flywheel) your picture is a direct drive.
  13. Scott Danforth

    90 HP early 80's 6 cylinder starting without key

    on a 2-stroke outboard, the key is used to kill the ignition (the off position grounds the coils) unplug the controls and jumper the starter and it should be running.
  14. Scott Danforth

    OMC Bayliner Trophy ignition q’s

    the terminal on the starter that used to be labeled "I" for ignition that provides full battery voltage to the points when cranking. that terminal may also be labeled "R" for relay. standard wiring for points style ignition.
  15. Scott Danforth

    4.3 EFI drainage ports

    there are 5 places to drain the block/motor/manifolds. the two on the block (one on each side) the two on the exhaust manifold (one on each side) the intake manifold thermostat cross-over then there is the cool fuel module, the raw water line to the PS cooler and the big hose. you will most...
  16. Scott Danforth

    Pro or amatuer hull repair?

    many one-hit-wonders over the past 6 months.
  17. Scott Danforth

    OMC Bayliner Trophy ignition q’s

    make sure it is wired properly to the starter I/R terminal you dont want to run points directly to a 12 volt source.
  18. Scott Danforth

    Who makes bimini tops which connect to the windshiled?

    Only way to do it is local upholstery shop, or a trip back in time in doc Browns delorean
  19. Scott Danforth

    1985 OMC 800 stringer with 350 chevy small block

    You have a stringer. The tilt is only used to get the outdrive up. If you need to run the motor with the drive tilted up, only at idle (600 rpm). It will tear the ball gears up. The trim is for adjusting the trim of the drive. My guess this is a new to you boat. I suggest getting a factory...
  20. Scott Danforth

    Mercruiser 5.0 TKS vs 4.3 MPI

    The 5.0 will perform great. I had one in my 2002 SeaRay 190 which weighed 3000#. I would hit 49.5 mph with 2 people. If I would have kept it, I was going to upgrade to a 4 barrel to hit low 50s
Top