Search results

  1. flashback

    How To Plug An Old Engine Into NMEA 2K

    Can't help you but I think your headed for endless problems.. that said, good luck!
  2. flashback

    Astroglass 1989 full rebuild

    You didn't buy that boat from Bondo did you?
  3. flashback

    What type boat to buy

    Probably not, the upkeep on a boat especially the boat your wanting is more than a millionaire can cough up. No matter what size it is they all are a hole in the water and gobble up the coin.. but it's always nice to dream...
  4. flashback

    Trailer tires lean

    I can't see how the wheels could lean in both directions without something being wrong with the bearings..
  5. flashback

    2000 Sea Ray 190 CC Hull Soft Spot

    Po mentioned spider cracks in the hull and being it's the actual hull there is no coring in that area. My guess is that someone hit something...
  6. flashback

    Don't forget that outdrive anti-fouling paint. . .

    Hate to think what the bottom looks like..
  7. flashback

    How to Remove Brass?

    I would.
  8. flashback

    Bad engine coupler or spun prop hub?

    Swap out the prop with a known good one to eliminate that possible cause...
  9. flashback

    Exhaust leak from lower unit?

    The mercrusier manual #14 is for the alpha 1 gen 2 which is probably what you have. It covers the outdrive. There's a lot of rubber bits that go bad over time..
  10. flashback

    Exhaust leak from lower unit?

    Get a hold of a oem manual so you can get familiar with what you're dealing with. Depending on previous maintenance you could be in need of some new parts. Prevention is a good thing.
  11. flashback

    Engine starts, idles for 10 seconds then dies

    OP mentioned that fuel was dripping in the carb, so he may have more than one gremlin...
  12. flashback

    Engine starts, idles for 10 seconds then dies

    Maybe some debris got knocked loose when you worked on the fuel line and it lodged In a pre filter or float valve... since you mentioned fuel dripping in the carb My guess is the float valve has dirt in it..
  13. flashback

    Engine starts, idles for 10 seconds then dies

    If this problem came up after installation of tee I would suspect it caused the problem.
  14. flashback

    Outboard engine on odd shaped transom

    The backing plate you installed on the inside should be sufficient.
  15. flashback

    Outboard engine on odd shaped transom

    That would depend on how well you backed up the engine mount. Looks good from here though I believe you will have quite a long reach to raise and lower it...
  16. flashback

    F-150 Transmission Issues (I think? . . . No, I thought )

    Well I'll get back in the back seat.. I'm not beholden to my 2001 GMC, most of the electronic stuff has failed long ago and I'm just waiting for the lights to burn out..:)
  17. flashback

    Project unknown

    What kind of paper work do you have for it. It could be a one off that someone put together?
  18. flashback

    F-150 Transmission Issues (I think? . . . No, I thought )

    Maybe take it out on the freeway and spool it up for a while, I'm thinking you have been running it a good bit below threshold and it may be fouled.
  19. flashback

    F-150 Transmission Issues (I think? . . . No, I thought )

    I've been in the back seat of this thread and you all have convinced me to keep my 2001 1500 as long as I can. I really don't need additional headaches...
  20. flashback

    In-water testing for overheat. How hot is too hot on your hand?

    The water pump impeller is a given, change it before you crank it up again and hopefully you don't destroy your motor..it gives you a baseline to work from...
Top