Search results

  1. flashback

    Connecting a electric fuel pump to 5.7LX

    I did a conversion last year and most all recommended a relay to power the pump.
  2. flashback

    Small engine replacement. LoveJoy shaft connector. How does it remove?

    The predator is 3/4 inch, I don't know what the B&S is.
  3. flashback

    High Voltage

    Don't know if your using the the meter in the helm for your measurement but sometimes they can go bad and you get a wrong reading..
  4. flashback

    Shift Interrupter Switch Unhooked however...

    You got away with it disconnected because you have a small engine, don't try it with a v8. My boat was like that when I got it and I promptly backed it into the shallows and tore up the prop. It goes into gear easily but getting back to neutral was a bear. I would hook it back up and see how...
  5. flashback

    Hook up boat engine to permanent magnet generator.

    I may be way off here, (i usually am) but if you did have a genny set up to the main engine my first thought was the fuel consumption would be much more than a small separate unit.
  6. flashback

    Rubbing compound for heavy oxidation

    I like 3M heavy duty.
  7. flashback

    Just 3 Words

    LOL.
  8. flashback

    Just 3 Words

    In the city
  9. flashback

    Just 3 Words

    Wandering, not lost.
  10. flashback

    Skeg Welding

    I would leave it as is.
  11. flashback

    Kind of a weird question on a/c for boat

    You might consider placing the unit on the dock an just duct the cool air to the boat. Keep noise to a minimum.
  12. flashback

    Need help deciding!! Wakeboard boat vs bow rider!?!

    Welcome to the forum. I can't help much here but I see a lot of wake board boats on Watts Bar and most all are bow riders. Other than ballast bladders I don't know what the difference would be.
  13. flashback

    LED Bulb trips breaker

    Maybe replace the breaker, they do go bad.
  14. flashback

    U-joint bellows ring

    Be sure the groove in the bell housing is nice and clean so the rib on the bellows can fully seat.
  15. flashback

    U-joint bellows ring

    I used a quart paint can filled with old drive oil to set the ring. It fits into the bore like a piston in a cylinder. I held a 2x6 block of wood on the end of the can and gave it a couple of good licks with a hammer. Be aware I have only done this once but it worked well for me..
  16. flashback

    What kind of rivets for aluminum boat deck?

    didn.t know they existed, learn something new every day! thx
  17. flashback

    1995 Searay 5.7 GM winterizing mods..

    I put this together and plan to install it in the raw water hose below the steering cooler.
  18. flashback

    Do you park your vehicle straight into your garage or back in?

    Guess you could put an exhaust fan in like we have in bathrooms and our I/O bilge blowers.
  19. flashback

    Method to repair damaged crank/ flywheel key?

    Since you said red neck repair, de-grease it real good and then put some red locktite on the shaft when you put it back together. You may not ever get it off again so be sure all is good..
  20. flashback

    First time water in bellows

    I got a greasable. From SEI this summer. Don't like sealed either. You may be able to pick the seal off and re pack.
Top