Search results

  1. Dukedog

    Mariner 1996 Outboard 150 [L] bogs down at 2k rpm

    do comp test first... don't run it any less tha 50 ta 1.... sounds like a carb issue.. do you have an oem manual?.. if not send me an email addy.. i'll get ya one.
  2. Dukedog

    175 2 stroke wont rev past 2k

    chunk tha "idle speed controller" (what ya call spark advance box) in tha trash... re do timing... after ya throw it away make sure ya have a white/black "jumper" (length is a non issue) between tha bias post on both switch boxes....
  3. Dukedog

    96' Merc 150hp EFI Smokes and surges when throttling up under load

    too much oil doesn't usually effect tha run part.. it jus smokes a little more.. we ran 24 ta 1 in our hot rods with no problems other than a little "smokey" at idle..... black/wet sounds like they are losin' fire for whatever reason....
  4. Dukedog

    96' Merc 150hp EFI Smokes and surges when throttling up under load

    may need ta send injectors out for a good cleaning... new o-rings..........
  5. Dukedog

    98 Mercury 150 running issue

    should be WMV's.. has screws.. WMH pumpers only made 1 year ('91), maybe a little of second year before they were dumped....
  6. Dukedog

    1998 Mercury 200hp block/part identification

    pictures of power head.. both sides and from top... any numbers/letters stamped on block half flange/port side?.. number stamped on welsh plug?.. build date at base of #2 block half, kinda behind tha bend in tha timin' arm.. will be 1/8" numbers mo/d/yr.. might be hard ta find but its there...
  7. Dukedog

    Merc 150 efi rev limiter

    A10 was in '96... merc was not real consistent with QC on their ecu's.. should be a "ruff" estimate on tha serial tag on tha clamp.. lotsa factors come inta play with max rpm so take it with tha typical grain a salt.............
  8. Dukedog

    Sport Jet 175 x2 with low compression

    ............. that motor has "electrionic" electrical junk.. it has a single box that replaces switch boxes and it also has an electronic ecu.. these can be a PIA ta diagnose ('specially ona computer)... you need to go by what your manual (if its tha right one?) tells you ta do for carb...
  9. Dukedog

    Sport Jet 175 x2 with low compression

    "I have tried a number of things, but just can not increase the idle." what have you tried?.. do you have an OEM manual for it?
  10. Dukedog

    Mercury kill switch wires

    Thought about installing kill switch but not sure how to wire it. after you get tha black/yellows straightened out you can install a "kill switch", between tha SOLID BLACK goin' to tha key switch and tha BLACK/YELLOW leavin' key switch.......
  11. Dukedog

    8-pin cable plug harness

    JAN.. that harness has nothing ta do with tha way a motor runs.. tha only thing it controls "as for its running" is it has a start circuit and a kill circuit.. it cannot change tha way, rpm and/or speed of tha motor.. it simply allows ta be started and/or shut down................ if it was...
  12. Dukedog

    150 EFI ongoing issue

    there were a few that said they could do it.. what i saw was some that could repair tha pump driver circuit (with success) and some that claimed ta be able change tha fuel map and raise tha limiter in some (not so successful).. i had a coupla of 'em done back in tha early 2000's without much...
  13. Dukedog

    1985 mariner 150

    yes, it will.... jus don't make a habit of doin' it.... normally bad high or low side of stator will not cause it ta die.. if high side is bad it will usually run jus fine up ta 28/3000 and jus quits pullin' but still runs at those rpm jus fine...............
  14. Dukedog

    1998 200 carb 2,5L

    jus unscrew it.. there is NOT an open hole in tha head... plug tubes on carbs... why ya wanna do away with it??? jus curious???
  15. Dukedog

    1987 MERCURY Black Max SR2

    "That was one of the differences" about tha only one that makes any difference..............
  16. Dukedog

    1987 MERCURY Black Max SR2

    tuner configuration/length....
  17. Dukedog

    1990 Merc 200hp xri efi

    it should NOT...
  18. Dukedog

    Fuel running out of carb when primer bulb is squeezed. Cleaned my carbs and the issue persists.

    find another WH-41 if your convinced tha "rebuild" did not take.. it happens with some of 'em for whatever reason.. been thru it myself with a few..........
  19. Dukedog

    1987 MERCURY Black Max SR2

    base 150 and XR2 150 are very much same thing.. XR2 uses different carbs, divider plate and tuner.. these will add a coupla hundred rpm to wot depending on your boat and how its set up... XR2? its more of a "marketing thing"... is it worth tha difference??? its up ta you.. with your boat...
  20. Dukedog

    1991 mercury 200hp EFI Black Max XRi

    check and/or rebuild mech. fuel pump for starters... could be a coupla other things also...
Top