Search results

  1. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    There is a bad connection somewhere My thought is that the wire would be close to the end of the tubing. Try looking at the other end of tubing and see how many wires are inside
  2. alldodge

    Just thought I'd share a nice photo.

    They are Gold Finch and redid vid to remove my name
  3. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    The left side (12V from Bat) wire is what should go to the choke coil on carb Peal the insulation tubing back from wire on the right to find the other wire that should be connected to the other
  4. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    Your motor does not have a mechanical fuel pump You have a break in a connection, don't know if that is inside the ALT or a wire. What your doing is back feeding the circuit The relay wasn't working until it was back feed Remember you have 2 diodes feeding the fuel pump relay, find them and...
  5. alldodge

    Merc 250 Verado Fuel increase

    Replaced the plugs and didn't notice any vibrations but also didn't take it out Called dealer and they agreed to take care of the overspray but I have to take it to them. I said thanks for admitting they caused it, but no thanks. Dealers is 1.5 hours away and who knows how long they will have...
  6. alldodge

    Honda 225hp

    Should not be an issue
  7. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    @kwanza1 noticed in your first post you mentioned that you were unable to get into your original account. Guessing it was @Kwanza so maybe @tpenfield can assist I don't have a wiring diagram for your exact model but do have one for GL-E which also uses the EST ignition. With the ALT not working...
  8. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Since there are 4 flat prior to radius, start with a circle saw with carbide blade
  9. alldodge

    What kind of dashcams is everyone using?

    Yes, the the socket stays hot, unplug it
  10. alldodge

    1981 MC-1 driveshaft reinstall into upper housing- any tricks to this?

    Take just the race and see if it fits, hope the housing isn't warped
  11. alldodge

    1981 MC-1 driveshaft reinstall into upper housing- any tricks to this?

    Manual says to use a hose clamp. If the sleeve is wider it may not have the bearings it correct position
  12. alldodge

    Installing Water Heater w/ closed loop 8.1 engine?

    In a house Cold comes in and Tees so cold travels on to all cold faucets and the other side goes into the hot water tank. It comes out of the hot water tank and goes to other side of all faucets The one for $369 is a 120V only and does not allow for the motor coolant to heat up water. Your...
  13. alldodge

    Pushing Run-Flat tires to the limit

    Have tire patched with plug and inner patch combo and never have an issue https://www.homedepot.com/p/Steelman-1-4-in-Tire-Repair-Patch-Plug-Combo-25-Box-JSG382/303437787?source=shoppingads&locale=en-US&fp=ggl
  14. alldodge

    Installing Water Heater w/ closed loop 8.1 engine?

    They all work the same and the motor will heat any and all of them. The issue just comes down to what size your good with
  15. alldodge

    Pushing Run-Flat tires to the limit

    Never had that type tire, good you made it I don't like changing a tire but in most cases the tire can be repaired so long as it's not on the side wall
  16. alldodge

    What kind of dashcams is everyone using?

    Don't leave it plugged in Most vehicles these days have a 2 position fuse the the 12V outlet. Look into your owners manual and/or fuse box. The fuse location should have 3 female pins, where it is now is full time 12V. Pull the fuse and plug it back in using the same center pin and the outside...
  17. alldodge

    Rotary Steering Cable.

    I would suggest contacting the manufacture of the cable and ask them how to measure and determine which cable would be best. This way if it doesn't work they have to replace
  18. alldodge

    Replacement Gauge

    That is a great find legalfee If you have the helm space I would suggest thinking about redoing the helm with separate gauges instead of all in one
Top