Search results

  1. alldodge

    PCM MEFI 3/4 Question regarding hours

    Here you go call Bob at OBD Diagnostics, he made MEFIBurn https://obd2allinone.com/mefiburn.asp
  2. alldodge

    PCM MEFI 3/4 Question regarding hours

    Online is just like this forum, you can find folks spouting off things they know nothing about. I could be lying to you, just take it all in and get enough to bring up a consensus. I own a copy of MefiBurn and have changed programing. Suggest go to Offshore only and find member ArticFriends...
  3. alldodge

    PCM MEFI 3/4 Question regarding hours

    MEFI's are easy to reprogram and in doing so it wipes out everything.
  4. alldodge

    Bayliner Capri 2150 resurrection.

    Don't put off checking the timing, if it's not correct the motor can be damaged. Check at local auto parts store for tool loan
  5. alldodge

    Would high fuel pressure cause misfire

    There isn't anyway to adjust timing with motor running. The motor is brought to TDC on #1 cylinder and dizzy is set in place. If the motor was not exactly at TDC then the timing is off
  6. alldodge

    Bayliner Capri 2150 resurrection.

    Looking good
  7. alldodge

    helm wiring, should be simple, i'm not too bright.

    If the things are grounded in other locations so long as they go back to battery ground, it should work without the buss on the fuse block The switches look ok so long as switch on the right showing a black wire does NOT go to ground, but something that needs power
  8. alldodge

    New Starter for 4.3l 3 post solenoid

    API 10105
  9. alldodge

    Bayliner Capri 2150 resurrection.

    Your pics are not working
  10. alldodge

    Bravo 1 to Bravo 3 Conversion

    Most probable cause
  11. alldodge

    New Starter for 4.3l 3 post solenoid

    Please clarify, I've never seen any starter to coil/points distributor connection on a Merc
  12. alldodge

    Would high fuel pressure cause misfire

    5.0 GXI-B Fuel over pressure might cause a miss due to excess fuel, but would more expect a backfire Have you checked timing? If timing is good I would suggest a compression test
  13. alldodge

    lack of power on 4.3 thunderbolt 5

    Set at 10 BTDC and it is advancing (getting to and hope fully past 20* BTDC) Start with the basics, compression test
  14. alldodge

    Volvo penta 5.0gxi 3869255

    The caM sensor uses 5V
  15. alldodge

    lack of power on 4.3 thunderbolt 5

    Check to see if the timing is advancing
  16. alldodge

    Volvo penta 5.0gxi 3869255

    If you have a connector on the side of the distributor than your using the Cam sensor
  17. alldodge

    Ujoints clunking?

    To clarify, the drive should never be run with drive full trim up, as in trailer position
  18. alldodge

    2005 Volvo Penta 5.7 OSXI-DF

    Looking up your fuel pump module HERE I find typical VP crap, they don't tell you what is in the pump assembly Next search for vp fuel pumps and find the one which fits
  19. alldodge

    TRANSOM ISSUES!!!!

    Wood is moist (wet) it will start to rot. Could inject some antifreeze to stop rot, but I think it needs to be replaced The finished transom should be 2 to 2.25 inch.If it's wider then 2.25 then the wood has expanded from the water
  20. alldodge

    Recommended wood for trailer bunks?

    I've always used treated pine and thru bolt with galvanized hardware. Stainless steel staples for carpet. The wood rots away usually before the hardware
Top