Re: mercruiser 170 wont stop cranking
i did some more poking around with my meter and the wire does turn to yellow/red after the big round connector. this boat is wired so weird. some wires change color when they go through different plugs.
i think i might of found an issue. when i tested the ignition switch(which is new but had been sitting) it was showing continuity between the bat and ignition circuit with the key off. the starter side was fine. After pulling the switch it works fine now.
do you think i can get away with using this solenoid or is it my problem? the white/green goes to switch then goes to a black wire that goes back into harness. is it designed to cut ignition or somthing?
after removing some tape i also found a black wire with an eyelet on it. my motor is converted to an alternator FYI
i did some more poking around with my meter and the wire does turn to yellow/red after the big round connector. this boat is wired so weird. some wires change color when they go through different plugs.
i think i might of found an issue. when i tested the ignition switch(which is new but had been sitting) it was showing continuity between the bat and ignition circuit with the key off. the starter side was fine. After pulling the switch it works fine now.
do you think i can get away with using this solenoid or is it my problem? the white/green goes to switch then goes to a black wire that goes back into harness. is it designed to cut ignition or somthing?
after removing some tape i also found a black wire with an eyelet on it. my motor is converted to an alternator FYI