Re: Tilt Leaking Oil Please Help!!!
yep,can be fixed,you should get a spanner wrench that will fit into the holes on the top of the cap where the piston comes out,ive seen guys use punches and hammers to knock em loose but dont recommed it,oh,the cap unscrews out,in case you didnt realize it,the two outer trim pistons are easier,the middle tilt can be a bear because of the pin that needs to be removed,if thats the case,you need remove the snap clip and find a drift pin or rod close to circumfrence of the pin,use a heavy hammer and hit head on,if no luck cause its stuck,try a little heat with mapp gas on a propane hand held tip,or you could bring it to the mech.the parts are availthey fit many different yrs,often they will want to sell the whole cap as a unit,but honestly,its usually the oring inside that goes bad and what is called the wiper,if you have corrosion issues,change the whole cap.if one is bad,the others may be close,lastly,hope the pistin isnt pitted,that can cut the orings,only by removing and inspection can you tell
