Search results

  1. S

    Quick question on steering actuator

    That is actually a phenomenal piece of advice! Luckily I am with small frame but hitting 60 things don't move as well as they used to.
  2. S

    Quick question on steering actuator

    I am of course trying to avoid that because there is no easy way to pull the engines it's a Monterey 282 and the engines are actually beneath the deck and I'm not sure how you would slide it forward to the engine hatch but I guess where there's a will there's a way
  3. S

    Quick question on steering actuator

    After I remove my waste holding tank which is on the starboard side of the boat I should be able to get my skinny frame all the way back to the transom so hopefully everything accessible on the starboard side including those two bolts I should be able to get pretty easily however I have not had...
  4. S

    Quick question on steering actuator

    Engine is a 4.3GXI-E twin
  5. S

    Quick question on steering actuator

    I will be needing to replace/repair my steering actuator soon. Access is very limited. Curious if it can be removed without removing the clevis pin that holds the steering cable. I think it will be very hard for me to reach that cotter pin, and if it is only holding the steering cable I think...
  6. S

    Volvo 4.3 gl overheating

    I had a blocked nipple on the thermostat housing (actually an eel - figure that one out). I did the real obvious thing and simply removed both manifold feed hoses at the thermostat housing and fired her up - she was in the water of course. Real obvious that flow on one side was restricted. If...
  7. S

    HELP!! 2001 Volvo Penta SX running hot

    Also - how did original engine fail?
  8. S

    HELP!! 2001 Volvo Penta SX running hot

    Are your risers overheating?? If not it would seem you have adequate water flow. Raw water cooled, correct? If you trim up slightly does the problem change? (indicates cavitation) Timing/Mixture effects engine efficiency - less efficient you will make more thermal energy and less mechanical...
  9. S

    Volvo Penta trim tilt hoses rebuild

    Whenever possible, I put vise grips over the brake spanner - keeps it closed so it does not slip. Of course some things are too tight for this.
  10. S

    Fuel pump whine

    I just wanted to add that I had a loud whine on a 4.3gxi-e shortly before failure. I probably put 5 hours on it while it was whining - I was being an idiot and trying to convince myself it sounded normal! I put one of those $200 knock off fuel cells on it while I rebuild the original fuel...
  11. S

    After market fuel pumps

    I have used 2 aftermarket pumps purchased on Amazon. One was installed spring of 2018 and still working fine. It is no longer available. The other was this one: https://www.amazon.com/gp/product/B076Q9RG1R/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Installed June of 2021. So the jury...
  12. S

    Volvo Penta Factory Fuel Pump - No better than aftermarket?

    I replaced one of my pumps with a cheapie off of Amazon in 2017. Everything about it appeared identical to the Volvo Penta original. I just replaced my other pump at the beginning of the season with another $200 pump (I have twins). Both are running fine. A fellow in my marina who busted on...
  13. S

    Volvo penta 4.3 gxi-q 2011 poor performance

    I was just going to say that when you have 1 fouled plug, usually an injector issue. Could be oil, but easy to check injector first.
  14. S

    Engine dumping fuel

    You either have a stuck injector or the ecm is commanding the injector to be on all the time. I would disconnect the injector(s) and try again. If it still does it, it is a bad injector. If not then it is the ecm. The pump continuing to run may be another problem (which may actually also...
  15. S

    I replaced the water pump impeller and now I have problem with overheating

    If you ran the impellor dry for any length of time (minute or more) it is most likely now damaged. If it had lube on it, it might be okay for a couple minutes. The pump cannot prime itself. In normal use it is below the water line and so is always primed. To test run on land it needs to be...
  16. S

    RPM issues can't get up to full speed

    Any growth on your hull? Since your engine will wind out to 4K no load mechanically (timing, valves and such) should be ok. Simple (but not always correct) cause would be restriction in fuel delivery. Restricted filter, clogged injectors, etc. Keep in mind you will not produce 65psi fuel...
  17. S

    Volvo 5.0 glx surging issue

    I am with Senior B on this.... and another clue will be if you high pressure pump is hot. The high pressure pump needs to be moving fuel to cool itself, and when there is no fuel in the tank fed by the low pressure pump it will starve and run hot - just experienced this myself. Oh - and that...
  18. S

    Starboard side riser temperature creep.

    Somewhere I thought I had read that the thermal switch for the riser temp activates at 210. I had one instance where I had the nipple clogged with an eel (try to figure that one out) - alarm went off and I lifted the hatch to see what was going on - had smoke rising off the riser and manifold...
  19. S

    Volvo SX-M

    SX-M is your outdrive model, not engine model. Engine model most likely 5.0GXI-something..... Should have a tag on it that states the model number.
  20. S

    Best aftermarket trim sender

    I bought 2 off of Amazon that had the highest reviews.... they were never quite right and one quit in the first year. So much for the reviews. I have seen OEM's suffer the same fate - hence why I tried no-name ones. I'm either going to try another no name, or implement what my late father...
Top