Search results

  1. tpenfield

    F-150 Transmission Issues (I think? . . . No, I thought )

    Interesting . . . So, you are thinking it could be the engine, not the transmission? I'll see what I can find out to see if that leads anywhere. I did an oil change along with the tranny fluid /filter change. I have the Actron OBD2 Code gadget . . . no codes. I think my total annual...
  2. tpenfield

    Mercury 9.8 110 2-stroke impeller question

    The hub of the impeller is brass. It can get stuck on the drive shaft. That is probably what you are seeing. I had to cut one off on my 7.5 (basically the same motor).
  3. tpenfield

    F-150 Transmission Issues (I think? . . . No, I thought )

    Quick Update. . . The snake oil (SeaFoam Trans Tune) is helping. The truck can hold speed on hills, but hard acceleration still gets the pulsating noise and slight tachometer upward movement. I plan on changing the fluid again in the Fall; as I am using the truck occasionally this summer.
  4. tpenfield

    Vintage Mercury Cooling Issue

    I installed some new spark plugs and took the boat out for a test ride. After 30 seconds of joy, the engine resumed running on one cylinder. I brought the engine home, pulled the flywheel and checked the coils for continuity (about 1 ohm each) and then I set the points, which were a little...
  5. tpenfield

    Bravo 1 low water pressure

    Your outdrive has the nose cone inlets as well as the side inlets. You should block off the nose cone inlets while running on the muffs. A cloth and a couple of bungee cords will do the trick.
  6. tpenfield

    Trim gage not working

    Greetings, I see that this is your first post, yet you have been a member for quite some time. Let us know what brand of engine/outdrive you have, as the thread should go to the appropriate engine forum.
  7. tpenfield

    What oil to use??

    Got a picture of the oil jug to post?
  8. tpenfield

    What oil to use??

    Sounds like you got motor oil and not 2-cycle oil. :unsure: o_O
  9. tpenfield

    Who here would buy a boat with 1400hours on a 454 mpi?

    I put 300 hours on the engines over 9 years of ownership, never looked back. No issues. Sold the boat and the new owner put another 150 hours on the engines.
  10. tpenfield

    Who here would buy a boat with 1400hours on a 454 mpi?

    Don't tell anybody, but I added closed cooling to a pair of engines that had 740 hours on them. Fresh water hours, so there was very little if any scaling inside the cooling system. I also did an acid flush of the cooling system to get rid of the small amount of rust that existed in the block.
  11. tpenfield

    water in engine, is it salvageable?

    It looks like a visible crack in the first picture. It is often easier to verify the cracks before disassembling the head & block. You really need to pressure test both the head and block at this point as some of the cracks can be internal. If/when water makes its way to the exhaust manifold...
  12. tpenfield

    1995 Chaparral 2550 SX Refit and Restoration

    Hi Drew, You mentioned setting the ignition timing to 10˚ BTDC . . . IIRC, shouldn't it be 8˚ BTDC at idle?
  13. tpenfield

    Looking for Good Used motor

    Closing this thread for multiple reasons.
  14. tpenfield

    Trim sensor adjustment

    @silver_power I've been following your threads (saga) in getting the engine sorted out. I am not familiar with the combo digital and analog gauge set-up, as I have the next generation of 3-wire DTS sender. (digital sender only = a blank on the stbd side of outdrive) But . . . Is the analog...
  15. tpenfield

    Astroglass 1989 full rebuild

    OK, I'm on for the ride. 😀 Looking forward to the updates.
  16. tpenfield

    Trim not working

    @Mnjk Welcome to iBoats . . . Please review the forum rule about posting to old/dormant threads. This thread is from last year and Tuckerboy has not been on the forum since then. Closed.
  17. tpenfield

    Bayliner Quality - what year improved?

    @Josaphin Welcome to iBoats . . . . Please review the forum rule regarding to posting to old threads and feel free to start a new thread of your own to get current input. Closed.
  18. tpenfield

    My boat is being a boat . . .

    Yes and thank you for your kind words. :) It seems that once I get one issue sorted out another one comes in its place. Right now my main issue is the delayed shift on the port outdrive. It makes things challenging at the dock as I usually have the port engine in forward and the starboard...
  19. tpenfield

    looking for a 1988 Doral Citation 260 owners manual.

    Welcome to iBoats, @Batchinguy . . . Please review the forum rules about posting to old/dormant threads. Closed.
  20. tpenfield

    My boat is being a boat . . .

    Probably why they fail at a fairly high rate. My boat went into service in June of 2016, so this is its 8th season in salt water.
Top