Search results

  1. N

    Chrysler Sea King 9.2hp Water Pump info

    Yes it should be -2 instead of -1. My mistake.
  2. N

    1975 25HP thermostat

    I have two 25Hp right now and have had at least six or seven of them and none of them hav had a thermostat. As jerry says, they made a place for one but did not use one.
  3. N

    Chrysler Sea King 9.2hp Water Pump info

    Maybe that one will fit, but the F429065-1 is for 9,2Hp if you check out Mastertech marine site. To be really sure contact Franz Marine, he will give you the right part number.
  4. N

    Need Points information for Sea King 9.2hp

    I do not have the parts list for this engine but I think the points are the same as for the later small Chrysler engines. It should be F12153-1. When I look at the pic and as you says you have spark but it would not fire maybe back fire I think you flywheel key is shared. The key should set the...
  5. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    As I said before your engine had the old style fuel pump from factory. The old style is mounted beside the block with a bracket. It is a two stage pump and it is driven from the crank case pulses (vaccum/overpressure) by two hoses. The newer style pump is bolted to the block at a intake port...
  6. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    Check out Ebay. There are 5-6 old style and 2-3 newer style fuel pumps out there. Search Chrysler outboard fuel pump.
  7. N

    Chrysler 1981 55HP Possible CD problem

    Joe I can not say if the magnetic field is strong enough but as the trigger magnet is smaller and it suppose to generate a low voltage to the CDI box to dump the capacitor voltage, it would not be so strong. I would suggest you to take a closer look at the trigger ring. As the triggers purpose...
  8. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    About the steering problem try to penetrate more with penetrating oil and warm/heat it up with a propane torch. Try to lobe with new grease through the grease fitting. Do not heat to much, there are plastic bushings for the swivel bracket bearing. It is a PIA to work with stiff steering but be...
  9. N

    Chrysler 1981 55HP Possible CD problem

    0,5 VDC or higher from triggers. 180 VDC or more from stator to CDI box (blue-yellow) connected. Orange and red are output to each coil. No spec. of output from CDI box to coil.
  10. N

    need starter for chrysler 70hp model 707hf availability

    As raceone says check the flywheel key. Really easy to check, pull the plugs and find the TDC at top plug with a screwdriver. At TDC the 0 dgr mark at flywheel should point and line up with the 0 dgr mark at timing tab. Also check the curved line at the distributor pull, It should line up with...
  11. N

    need starter for chrysler 70hp model 707hf availability

    Do not buy a cheap starter from China. Rebuild you OEM starter, the cheap Chinese or Taiwan starter is junk.
  12. N

    Chrysler 1981 55HP Possible CD problem

    Pull the flywheel off if you haven´t yet and check how it looks like. The magnet is a thin strip that is glued to the flywheel outer rim and it serves the stator windings charging the CDI box and battery. It is not uncommon the magnets get loose but then you loose spark. The trigger pick up...
  13. N

    Chrysler 1981 55HP Possible CD problem

    Well, I have no more information to add now. I think you have to change parts by now as it sparks and suddenly change the firing order. There are used CDI boxes at Ebay, but better to buy a new OEM or an aftermarket by CDI Electronics. CDI Electronics part number 116-5301, but really expensive...
  14. N

    Chrysler 1981 55HP Possible CD problem

    My OEM service manual Force 35 and 50 Hp calls for orange top cylinder and red for bottom cylinder. The 50 Hp Force has the same ignition system as your 55Hp Chrysler.
  15. N

    Chrysler 1981 55HP Possible CD problem

    But if you can not connect the prime side of the ignition coil wrong cause the connectors only goes one way there are ignition coils dedicated for cylinder one and cylinder two. You are not able to switch the ignition coils. I believe you can swap the coils, that is what I remember. But it was...
  16. N

    Chrysler 1981 55HP Possible CD problem

    This is a self generating magneto CDI system soo battery would not affect the timing. Only if the starter turn to slow soo the magneto do not produce enough power. Battery only for the starter and aux. The stator has windings, one charging the CD box (blue and yellow wires) and one for the...
  17. N

    Wiring a kill switch to 85h chrysler magnapower

    Use a NC (contact closed when lanyard is in) lanyard and wire it in series with the keyswitch blue (ignition) wire and kill switch. The ignition is a battery system and the battery is charging the capacitors in the Motorola CD box through the red wire and the blue wire enable the ignition coil...
  18. N

    73 Chrysler 85hp won't start

    You are welcome. Was it way off? Flywheel key shared?
  19. N

    running rough at idle

    Removing old gaskets i use razor blades or a papper knife with a thin blade. There are gasket remove tools at the tool market, they work but be careful when you working on aluminium alloy. Easy to make scraps.
  20. N

    Chrysler 1981 55HP Possible CD problem

    Spark at one cylinder but only 0,05V from both triggers? If you got only 0,05V from both triggers you should not get any spark at all at both cylinders. 0,05V from the faulty cylinders trigger, yes you have a bad trigger there.
Top