Search results

  1. jerryjerry05

    1984 force 125 fuel pump question?

    Some of the products your buying could be 10-20 years old. One tiny backfire or cough can cause the diaphragm to rip. If you have reoccurring problem?? install 2 diaphragms in the pump. Like Racer said, use the Mercury products.
  2. jerryjerry05

    88's Gamefisher impeller parts

    Most times the impeller is all you need. Unless the housing is REALLLLY bad I wouldn't change it. Take it apart and get some pics. and post them.
  3. jerryjerry05

    Spark plug wires on an 89 Force 50 hp

    The boots changeable. A touch of Dialectric grease on the end of the plug might help with the rust. But too much will cause the boot to fall off. Some cases the wire needs to be helped, use shrink tube and Liquid Electric tape to cover the wire.
  4. jerryjerry05

    Force Outboards Rated By Model

    Topgun was right about the 70 and the Helldrive. The one carb on the 70 was a real bad idea. They cooked more #1 cyl. because of the crappy design. I didn't like the 150 all that much either.
  5. jerryjerry05

    Need a Stator for 1994 Force 70 Outboard

    DVA or Peak Reading Voltmeter. That's what you need to take the readings on Force outboards.
  6. jerryjerry05

    50 hp high speed misfire

    ANYTIME!!! you have a miss you should do the starting fluid test. Start the motor, spray starting fluid around the intake side . This includes under the coil/pack bracket the carb bases and around the port covers. If the spray makes any difference?? then it's got a bad gasket and sucking air.
  7. jerryjerry05

    '87 Force 125HP ignition problem

    I'll say it again!! A stator that tests good, can be bad :) Actually I've said that a bunch of times.
  8. jerryjerry05

    1989 Force 125 water pump torque values

    70 inch pounds is like 6/7 pounds and not very tight. You worried about them backing out?? A touch of sillycone or lock tite.
  9. jerryjerry05

    Crack in cylinder wall, need insight....

    My opinion: a cracked cylinder is just the beginning of the funeral.
  10. jerryjerry05

    Lower Unit shifter on Sea King 9.2

    Thanks
  11. jerryjerry05

    85hp Force lower unit disassembly? Stuck driveshaft...

    at least 2 Special tools. Not a lower unit for an 85hp. 94 to 99 Force lower.
  12. jerryjerry05

    Do all forces have overheat buzzers?

    IF??? your motor came with the controls?? then it might have a buzzer. TEST: turn key on(not running) then ground the orange lead from the back of the motor. That should make the buzzer sound off. The controls might have the buzzer built into it.
  13. jerryjerry05

    50 hp high speed misfire

    Do the starting fluid test. Start motor, spray SF around the intake side of the motor, that includes under the coils and pack, around the port covers(2) a the base of the carb. The port covers have a gasket that can fail with a misfire, cough and stutter allowing the motor to run crappy.
  14. jerryjerry05

    Need to adjust the dial 1990 Force carbs mixture

    Yes 28 is ok.
  15. jerryjerry05

    The fall

    How'd you break and then dislocate 3 on the other foot?? Bet that hurt :)
  16. jerryjerry05

    Need to adjust the dial 1990 Force carbs mixture

    1990 WHAT??? The 3cyl. the carbs are set at 1 turn and left there. "Factory direction" You might need to adjust them and 1/8th turn should be all you need. The 125/120/150/50 all need to be set at 1 1/2 turn out then adjusted from there. In the water. Warm motor and in gear, slowly turn the...
  17. jerryjerry05

    The fall

    Thanks, it's slowly getting there. Just real careful where I put my feet.
  18. jerryjerry05

    The fall

    Last week I found how far down the ground is. I tripped over a jack stand and landed on a Mercruiser lower unit and a electric scooter. I thought I broke my arm/shoulder. Nope, just scraped and bruised everywhere. Haven't been able to move good or at all. Younger, I would have bounced, not...
  19. jerryjerry05

    Why does everybody hate Force?

    Force and Johnson around 1988 85hp. Both got about the same mileage. A customer had a 23 225 and my 21 with twin 85 Forces got just about the same 3.2 mpg. Force was actually cheaper to fix than ALL the other outboards. AND there was NO MAJIC in fixing them, just get the manual and a DVA meter...
  20. jerryjerry05

    Force outboard maintenance

    88/50 That's a good motor and can last a long time. The others have covered just about all on the regular list. Gonna add 1 thing. The Force/Chrysler can develop a problem. I call it the starting fluid test. Start the motor and spray starting fluid around the intake side of the engine. That...
Top