Search results

  1. 04fxdwgi25

    No lights on the Trailer there is but power at the Wires

    And NEVER use / depend on the trailer ball for the ground between the vehicle and trailer.
  2. 04fxdwgi25

    Dust Cap Woes

    Sure looks like a bunch of rust in there, ie: water in the hub. Hint: use a caliper to measure, as a ruler won't get close to a 100's of an inch. Your ruler measurement is meaningless in this situation.
  3. 04fxdwgi25

    Bravo 1 vs 3 gimbal housing ?

    What year was the original one and what motor was it? That top circled one is for the drive oil line fitting. The missing hole, I don't know, but the pitot tube line goes in the other one. What was all connected on the original one? The old one almost looks really odd and doesn't look anything...
  4. 04fxdwgi25

    Inoperative Gauges

    Buzzing sound is the fuel pump, if you have an electric one. Does the red wire have power all the time? It should when battery switch is turned on. If not, bad circuit breaker back on the engine or bad wire / connection somewhere.. Put a meter / test light on the yellow wire and turn to...
  5. 04fxdwgi25

    Trim hose from manifold to inside

    As long as the correct port on the pump is connected to the correct external hose, it will work. But the external hoses will interfere with each other is not positioned correctly. Personally, I would correct the internal hose connections on the manifold. Not knowing which pump you have, you may...
  6. 04fxdwgi25

    BRAVO 3 RATIO

    On my 22', running a 454 mag and B3 with 2.0 drive and 28" props. On a 28 footer, I believe they call for the 2.2 drive ratio
  7. 04fxdwgi25

    Temperature Gauge Not Functioning Mercruiser Alpha One, Help.

    That could be a problem. I would seriously consider a new harness / replacing the plug with one from a donor harness.
  8. 04fxdwgi25

    Bearing Buddy dust cap "bra" coming off 1 hub while trailering

    ^^^ What Airshot said. Captured air in there expands as it heats during operation and will push them off.
  9. 04fxdwgi25

    Spare battery

    I consider it lousy cable management. Cable could be exposed to water and oil, which in general, is not good for the insulation. Just spring for an extra couple of feet of cable, route correctly and secure correctly, instead of flopping around in the bilge. That's just me.
  10. 04fxdwgi25

    Spare battery

    Preferably, I would want to keep the cables out of the bilge
  11. 04fxdwgi25

    Outdrive oil leak..

    Sent you a PM
  12. 04fxdwgi25

    Outdrive oil leak..

    Item 6 is the oil passage o-ring seal
  13. 04fxdwgi25

    Inoperative Gauges

    There should be a fuse for the gauges. My last boat, a Chaparral, had one. They make those wire harnesses pretty tight and a crappy / loose connection on a wire terminal is not unheard of.
  14. 04fxdwgi25

    Tach for a Sea Pro

    From what I found, SeaPro uses Telflex for the tach's. Just a std tach. Only caviate is the one's with the alarm telltale lamps in them are hard to find.
  15. 04fxdwgi25

    Mercruiser 3.0 Alpha One Gen 2 Barrel

    Perhaps I am unsure what point you are trying to make, but...... Ummmm. The muffs are run on a garden hose under pressure. Therefore, the raw water pump wouldn't need to pull a suction to draw water (lift) to prime it. The hose pressure forces the water to the pump to prime it.
  16. 04fxdwgi25

    new engine turns-does not start

    Blown fuses? tripped breakers?
  17. 04fxdwgi25

    Adding A Stern Mounted Trim Switch

    Go with the Mercruiser one that JASinIL2006 linked to.. Super easy and will work.
  18. 04fxdwgi25

    4.3 Carb…What’s That Hose?

    Safety inspections will specifically look for the yellow tinted hose to ensure it's fuel proof. Clear Tygon will stand up to the fuels, but the cheapo PVC clear tubing (same stuff they sell for fish tanks) also available in the HW stores wont do well with the chemicals. Problem is, it's hard to...
  19. 04fxdwgi25

    4.3 Carb…What’s That Hose?

    Yup, clear so you can see if there is fuel in it, but don't use the clear hose you find at the hardware store on the reels. That hose is yellow so the know it's approved hose by a quick glance.
  20. 04fxdwgi25

    Mercruiser hose hanging from exterior transom components

    Yup. speedo pitot fitting (for the in-dash speedometer). But, it is broken off where it plugs into lower unit, meaning the other half is probably still in there. Probable cause was removing drive unit, not realizing it was inplace there (or it was caught up on something else during removal) and...
Top