Search results

  1. bruceb58

    Chaparral Mercruiser Prop Question

    Talk to Bryan at Valley Propellerthe guy knows his stuff. I use Solas propellers on my Bravo 3. Bryan has the best prices. https://www.valleypropellerservice.com/
  2. bruceb58

    Low voltage to fuel pump relay

    deleted
  3. bruceb58

    Low voltage to fuel pump relay

    When you said you had two diodes in your original post, I knew you had a carb. I actually missed the model number part of your post.
  4. bruceb58

    TRAILER WANTED

    Have you posted on the Cobalt forum? Cobaltchat.com BTW, those forward drive trailers are hard to come by and typically need to be made to order since they are so unique.
  5. bruceb58

    KIA Telluride for towing?

    A Road Disaster and a funeral home vehicle!
  6. bruceb58

    KIA Telluride for towing?

    Yes 470 ft-lbs Your Jeep Grand Cherokee has a wheelbase of 109.5"....that is even less than the Kia Telluride that the Op was asking about. Sorry...but that is dangerously low unless you are towing a couple miles to a ramp like you apparently do. Bottom line, the Cherokee is a **** poor towing...
  7. bruceb58

    KIA Telluride for towing?

    That's funny...I don't see you mention turbos anywhere! Too bad the Jeep is such a lousy tow vehicle with its short wheelbase and lousy payload. What is your payload on your Jeep..1000# or so? Also, you can't even get a V8 in a Jeep Cherokee anymore.
  8. bruceb58

    KIA Telluride for towing?

    My V6 F150 has 470 lb-ft of torque! and it does that at 2500 RPM.
  9. bruceb58

    Best carpet for trailer bunks

    I buy my bunk carpet on eBay.
  10. bruceb58

    Low voltage to fuel pump relay

    It will receive 12V to the relay coil while cranking(through diode from starting circuit) and then once the engine starts, it will get 12V from the alternator, also through a diode to that coil.
  11. bruceb58

    HELP: Rusted bolts on leaf springs

    When I replace spring bolts, I replace with ones you can lube. https://www.amazon.com/Rigid-Hitch-Greaseable-B-201-10-Locknut/dp/B07D5LT639/ref=sr_1_1?crid=1OHMVSTK75QH1&keywords=lubed+spring+bolts&qid=1691246108&sprefix=lubed+spring+bolts%2Caps%2C170&sr=8-1
  12. bruceb58

    White Ground wire

    No need for electrical tape
  13. bruceb58

    White Ground wire

    I do a ground to the frame at every light fixture. I then paint over it to basically seal it.
  14. bruceb58

    2023 NFL/CFB News and Nonsense

    Not very smart https://sports.yahoo.com/report-vikings-1st-round-pick-jordan-addison-cited-for-reckless-driving-speeding-85-mph-over-limit-185746672.html
  15. bruceb58

    Dust Cap Woes

    Basically using a center punch from the inside to dimple it so you have a small protrusion looking from the outside.
  16. bruceb58

    Dust Cap Woes

    Pretty easy to dimple a cap from the inside with a punch. Put 3 or 4 dimples in and it will never come off. If it's a Bearing Buddy...A lttle harder to do but supposedly can be done. I had this problem once and when I switched to higher quality hubs, problem disappeared.
  17. bruceb58

    If you have a roller trailer used in salt water....check this....

    Elsewhere in So Cal means ocean. We have over 7 foot tides at times. Today we have a -1.6 followed by a 6.8 later. As far as launching at high tide vs low tide, our ramps are the same angle no matter when you launch so it really doesn't matter if you launch at high or low other than the amount...
  18. bruceb58

    If you have a roller trailer used in salt water....check this....

    At lake Tahoe, Big Bear Lake and elsewhere in so cal...not one roller trailer to be found. My latest boat is a Coblat....NO Cobalts get sold on roller trailers....NONE!
  19. bruceb58

    If you have a roller trailer used in salt water....check this....

    It's easy to look like a pro when launching a small boat.
  20. bruceb58

    If you have a roller trailer used in salt water....check this....

    deleted...not worth the bandwidth
Top