Search results

  1. S

    Blown head gasket / overheat

    Good to know, maybe this will help others.
  2. S

    2016 etec 90 hp skip after injectors cleaned and 1 new

    There is a little more info on etec's over in this forum. https://www.etecownersgroup.com/
  3. S

    2001 Johnson 50hp

    Sounds like you had a runaway motor event.
  4. S

    Johnson V4 Crossflow Throttle return

    Was it on a different thread? Doesn't show it on mine when I go back, weird.
  5. S

    Overheating at idle, cool as a cucumber at speed

    I'm thinking you plugged the intake screen and possibly burned up part of the impeller and the rubber bits are moving around causing havoc. Pull the lower end and look at the water pump. Should tell the story.
  6. S

    Johnson V4 Crossflow Throttle return

    I use white lithium grease.
  7. S

    Johnson V4 Crossflow Throttle return

    Post #1 of this thread started today at just after 1pm so not sure what your reading.
  8. S

    Johnson V4 Crossflow Throttle return

    What post was that? Also, he said cable on or off.
  9. S

    Johnson V4 Crossflow Throttle return

    Probably dried up grease under the timer base gunking it all up.
  10. S

    98 Johnson leaking hydraulic fluid.

    I stand corrected...I think it's like a split washer.....been a long time since I've seen one.
  11. S

    Blown head gasket / overheat

    I thought the port side heat sensor is the one that no one has except used.....are those available somewhere?
  12. S

    98 Johnson leaking hydraulic fluid.

    That should be a c clip not a washer.....
  13. S

    1985 Johnson 140 engine wireing diagram and color coding

    I couldn't find them.....
  14. S

    1985 Johnson 140 engine wireing diagram and color coding

    It would be nice if it had the legend for the wiring color code.
  15. S

    1985 Johnson 140 engine wireing diagram and color coding

    I believe the wiring should be the same.
  16. S

    Gear oil milky?

    Years ago I use some lubermatic marine gear oil and it came out something like that. I put in a jar and took it to a Evinrude dealer and showed it to a mechanic and we both determined it wasn't water. Never used that oil again and never saw it like that again. You might be ok but I would do a...
  17. S

    1992 evinrude 150 EXEN vacuum line diagram

    Usually it goes into the wiring harness area....not sure if your motor has one. Others might know.
  18. S

    1992 evinrude 150 EXEN vacuum line diagram

    Not sure your question, but some outboards have their own speedo tube. The gearcase has a little hole that routes water up through the motor to a speedo on the dash. From the cowling you have to run your own tube.
  19. S

    Evinrude 15 1992 carburetor cover change

    Why would anyone do that?? And what I don't understand is in your original picture they were sticking out....how did the plastic cover even go on? You need a close up of someone else's carb.
  20. S

    Blown head gasket / overheat

    Sounds like it could be a bad wire somewhere but maybe some gunk moving around....definitely a head scratcher. When you had the heads off did you true them up?
Top