Search results

  1. A

    Prop Question

    Actually, "nothing" is better than college is today!! Just look at the math abilities of todays college grads...they can't do the math to pay back their student loans !! Math a 9th grader should have no problem doing !!
  2. A

    Propane

    Been using propane for many years, also own my own tanks, but I have found that it doesn't take much change in weather to cause a big difference in usage!! I buy from the lowest bidder in my area, my two tanks last me all year with a small reserve in case of extreme use. There are a few...
  3. A

    No Power to Boat

    Connections need taken apart, cleaned till shiny then a dab of grease and reconnected tight !! Battery needs to read 12.6 volts or higher ! Start at the battery and work back to the motor, where the voltage stops, you will find your problem.
  4. A

    Need guidance on Prop pitch and Power, 78 Johnson 55hp 55EL78S

    Get your motor fixed and running properly, then figure what prop you need. The good folks on here are trying to help, if you don't wish to heed there advice, why did you ask??
  5. A

    Adding a Splashwell

    Can be trickey depending on how transom supports are attached ... Might need to visit a sheet metal fab shop if you don't have sheetmetal bending/ fabricating experience. There are also some generic units thst can be bought and modified to fit. Pics of yourvtransom might help ur to make...
  6. A

    Prop Question

    The poster needs to understand that max rpm is the engine rpm. Adjust the prop pitch to get the max engine rpm....forget any other shaft speed !!
  7. A

    Fuel line for pressure tank

    Very nice and clean motor !! A rare long legger as well, not many 20" transoms back in those days. As a young lad, I was getting into boating when that was made. Thanks for the pics
  8. A

    Bimini install measurements?

    Might be able to point you in the right direction with some pics.. Once set up correctly they are quick and easy to put up and down. I raise and lower mine by myself, takes about three minutes to put up or take down. Takes longer to zip the boot on or off...
  9. A

    Overheat alarm at idle... I think??

    First thing to do is get your hands on a " factory service manual", forget the aftermarket manuals as they are only good for spare toilet paper !! The manual will describe what the beeps mean and what to check. Each motor can be a little different. Or...you can throw parts at it and hope...
  10. A

    FourStroke 75 ELPT / 6 Beeps / New Boater

    Sounds like weeds or other debris is clogging your water intake and causing an overheat at speed.
  11. A

    Bimini install measurements?

    Review the video again, pretty simple to follow. Poles should be marked, assemble then sit on the gunwales and decide where you want it. Rule of thumb is a three bow is a 6' long top and the hinge point is usually in the center ( 3' ). Depending on where you want the top to rest when not in...
  12. A

    Fuel line for pressure tank

    Good lookin ole motor, hope it runs well for you ...post some pics for us when she gets underway
  13. A

    Best carpet for trailer bunks

    I used staples as well just to hold in place, then went back over with galvanized roofing nails, they make ones with larger heads, they hold really well don't rust out
  14. A

    Bimini install measurements?

    6' three bow is what I put on my 16' Sylvan...I would never attach a strap to any windshield !! Not hard to find a small space for the U strap to attach the strap to. And the straps are adjustable to alter there length easily. Once the top is in the position you want, then figure where the...
  15. A

    Bimini install measurements?

    I was lucky as I have two grandkids over 20 yrs of age to act as my holdowns while moving it around ! Help is always a good thing...
  16. A

    Bimini install measurements?

    I just instalked one on my 16' Sylvan. It will never be in that exact perfect position because the boat moves and so does the sun!! Most are way to tall, so when you sit down, the sun comes in under the side and the top becomes useless. One thing you can do to help is add sliding rails on...
  17. A

    Trailer needs new axle. Need ideas.

    An easy plug and play is probably not an option....your gonna need some professional services along the way. One way or another your gonna need to spend some money....by a new trailer, have a new axle and hubs made, or pay a shop to modify the one you have...life is all about choices !!
  18. A

    Can’t get on plane

    The mechanic didn't do his job, so why did he get paid ?? Take it back and tell him to fix it right !!
  19. A

    Trailer needs new axle. Need ideas.

    Can you cut off and just replace the axle stubs ? Did that on my old trailer years back, just matched the inside dia of the hollow axle and welded in new stubs.
  20. A

    Wild goose chase looking for our perfect 2nd boat?

    Been a boater for 60 years, owned to many to count, each has its pros and cons!! Never found one boat that does it all, besides....life changes and so will your wants and needs..
Top