Search results

  1. S

    2000 Evinrude e150fpxssv power trim issue

    If it turns out to be the motor I would buy the OEM new one or a low cost used one....but I get them basically free when I buy a parts motor.
  2. S

    GLSTA 115 Low rpm idle

    500 RPM's is to slow. Sometimes higher than after you run it it goes down?
  3. S

    GLSTA 115 Low rpm idle

    7/16.....nice blue spark.
  4. S

    GLSTA 115 Low rpm idle

    Ignition coils and power packs are aftermarket? I would do a spark jump test.... Could you have messed up the carbs?
  5. S

    Motor and PT&T identification help!

    Well I'm unfamiliar with those then.... I didn't see the second cylinder in the original picture. Wonder how that works...must be tough on the cylinders. Anyhow I looked at 1975 and I couldn't find one in the parts list. 1980, I did and it's just like yours. Good chance yours is original or in...
  6. S

    Spark or No Spark?

    Nice to get such detailed feedback. Always helps when trying to deal with complete strangers!😉 Best of luck with that beast.
  7. S

    Motor and PT&T identification help!

    No twin cylinders and crush pads. I'm staying with tilt only. Maybe others will confirm and I will have learned a new thing.
  8. S

    GLSTA 115 Low rpm idle

    Do a cylinder test ....(Pull plug wires while running) Sounds like 2 cylinders are down....test to confirm. (Wet plugs electrical, dry plugs fuel) Report back and people can tell you what to do next.
  9. S

    Motor and PT&T identification help!

    By the way, that's not a t&t....it's a tilt only.
  10. S

    Motor and PT&T identification help!

    Best I can do is tell you that's an 80's motor....now is this yours or the other one? If we can see both maybe we can identify compatibility. Pictures under the hood would help identify as well.
  11. S

    1983 Evinrude 35HP lower unit compatability/interchangeability?

    If it was "jerking in and out of gear" in both forward and reverse than I'd say you have the linkage adjusted wrong. Small chance it's your prop....you would hear the motor wind up though. Oil won't save it if the dogs are rounded off.
  12. S

    1983 Evinrude 35HP lower unit compatability/interchangeability?

    There's quite a few years and lots of hp range....25, 30, 35hp. Easier to look at the parts breakdown if you see or hear of a motor for sale. You understand that the lower end failed because you didn't check and maintain it right? It takes awhile for water to ruin it. Change your gearcase oil...
  13. S

    1987 johson 225 hp power issues

    I said it didn't look like anything the coast guard uses not that's not a ex-coast guard boat.... I even complimented the walk around deck. People read comments and miss take the body of the message. Good luck with your motor.
  14. S

    1974 Evinrude 70 HP Charging system install

    Amperage goes up but voltage is negligible. Rectifier works with the battery to stay within limits. Some of it is above my pay grade. It will get over 13 volts.
  15. S

    1987 johson 225 hp power issues

    Doesn't look like something the coast guard would use... Looks like a walk around. Should serve you well. I live in Seattle, is that we're you and the boat are?
  16. S

    1974 Evinrude 70 HP Charging system install

    You don't see much especially at idle. I hook up my meter and watch it slowly work it's way up. It's not like a car.
  17. S

    2013 Etec Steering Question

    Simple....excellent job, way to use your noodle. 😉
  18. S

    2004 Johnson 25hp 2 stroke sputtering or bogging

    Try squeezing the primer ball on the gas line when it bogs down. Fuel pump could be the issue or dirty carb. Post results.
  19. S

    Impeller kit number?

    Does your motor still have it's vro?
  20. S

    Impeller kit number?

    0438602 That's the whole pump kit.
Top