Search results

  1. S

    Electrical issue.

    Exactly....he was on the water on Saturday and the battery's were at 12.75 today....bounced back well. I had already done a full battery test 30 days ago and taught him how to run two batteries correctly. His first battery, or the volt gauge kept dropping he said (non-digital gauge), then he...
  2. S

    Electrical issue.

    Alternator, fuse able links and battery's test ok but alt is singing, hotter than hell and stinks like burning electrical. Best guess the alt is on its way out. Let me know if you don't agree.
  3. S

    Electrical issue.

    3b018824
  4. S

    Opinion on Evinrude 25hp not peeing

    First video is labeled private. Remake that video. Your hand pump might pump more velocity than your impeller so not sure if that test proves anything. Grommet, gasket, cracked block could be issues but usually it's something dumb.
  5. S

    Electrical issue.

    It's July and the Seattle Washington area and fishing is hot. So if you have something wrong with your motor you're basically screwed cuz all mechanics are booked up. Friend of mine called with a Merc and I said I'd try to help him out. It's a 2019 150 4 stroke Merc. Picture is the model number...
  6. S

    OMS help needed

    Your referring to the optical sensor pickup ...they still had a plain old vro.... Alarm sounding on start up only, means that the horn works.....it does not mean the system works. Learn how to test that all your warning systems are working correctly. Much info on this out there.
  7. S

    OMS help needed

    What's an OMS pump.....should just be the vro pump. Inexpensive diaphragm flap. Better question is is why didn't the low pressure oil alarm go off. Also, there is a check valve issue with those. Try running it with the oil cap off the oil tank. (Check valve test)
  8. S

    Customer advice

    He just sent me more pictures after he honed it out. Plus these readings. Did a light cleanup with the hone. Cylinders measure right at 3.217 and the spec for .030 over is 3.217 - 3.128. Think I might just hone them a little more and slap some new .030 over pistons in.
  9. S

    not going very good

    Fuel pump or carb clean/settings not done properly. This assumes compression is acceptable. Full diagnostic of this motor is needed.
  10. S

    My 1986 Evinrude 28 SPL lost the small Cam Follower.

    I second that part number
  11. S

    Customer advice

    Sent, email
  12. S

    Customer advice

    Still can't send a picture.
  13. S

    Customer advice

    Still can't upload the picture.
  14. S

    Customer advice

    Test Yes a picture of a piston and rod....just tried again. I will try later
  15. S

    Customer advice

    Not sure what this means.... Upload failed....admin....blah blah blah....did that yesterday.
  16. S

    Customer advice

    Now he's convinced it's savable. Are those knurled pistons?
  17. S

    Engine dies under a load

    Going to get my chest waders on....it's neck deep in here.
  18. S

    Customer advice

    Yes the infamous diode.....we must check that!
  19. S

    96 evinrude 20 hp runs rough mid range

    Compression is basically no good....not worth doing anything. 4 years ago is a long time. Running the motor not hooked up to the battery ruins the rectifier but I guess your never ran that way. Time for a parts motor with a good power head.
  20. S

    Engine dies under a load

    Most motors will run good underload because they are ....underload. Your motor is mechanically shot. Rebuild or buy something else. Tough lesson but your in a very large crowd.
View older results
Top