Search results

  1. S

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    Carb.... Advancing the carb throttle without the timer?.....well not sure. Spray something like carb cleaner or propane into the carb shaft at idle and report. Might just be a bad carb.
  2. S

    96 johnson. Link and sink

    What specific linkage are you talking about. https://www.marineengine.com/parts/johnson-evinrude-parts.php?year=1996&hp=150&model=E150EXEDB&manufacturer=Evinrude&section=THROTTLE+LINKAGE
  3. S

    96 johnson. Link and sink

    Send a.....pictures are down. Make a YouTube video of the area and send us the linc
  4. S

    Starts and idles fine, but cannot get full speed (1985 Johnson 140 hp - J140TLCO)

    You could also try eliminating the control box as a problem by starting it, disconnecting the red plug at the motor and see if it's still a problem. Are your butterfly's opening all the way? I'm thinking they are.
  5. S

    Starts and idles fine, but cannot get full speed (1985 Johnson 140 hp - J140TLCO)

    Sorry, platform looked up for some reason. Try unhooking the temp sensor at the head. Unhook the wire and see if that gives you some joy. I.Boat system still won't allow to post pictures but it's part 28.
  6. S

    Starting Delay 1986 Johnson 150 HP Crossflow V6

    Ignition switch or solenoid.... Flip a coin, good guesses really. Something is going, buy new parts and throw them in the glove box.
  7. S

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    So you've moved the coil and spark plug up one and what happens? It moves or stays?
  8. S

    96 johnson. Link and sink

    And 96 Johnson what?
  9. S

    96 johnson. Link and sink

    Not exactly sure what you're saying or asking, but it sounds to me like you're not setting your throttle cable right.
  10. S

    Going from 25 hp to 35 hp

    Is that 96 engine a 3 banger like mine?
  11. S

    Going from 25 hp to 35 hp

    Get a 40....big difference.
  12. S

    Fixed but nervous

    No....it will not but if it fails and you overheat the engine, bye bye outboard. It can test fine (with a volt meter) but when you put that kind of amps through....then that condition applies.
  13. S

    Fixed but nervous

    Yes, kill circuit can be intermittent. Corrosion was most likely your problem. Did you test your overheat system? I do mine every year.
  14. S

    Going from 25 hp to 35 hp

    HP is HP....often times when your using the same block size kick out of the hole and getting on a plane are better. My 2 cents.
  15. S

    J40ELCR WOT needs key pushed and released for full power

    Cracked fuel lines indicates replacement light unless you like trouble.
  16. S

    E starter won’t engage.

    What's your battery voltage at the battery, at the solenoid and finally at the starter while cranking. Post numbers and we will tell you were your problems ly.
  17. S

    Water leak at lower unit - 1977 70 hp evinrude

    It went down about a week ago and the moderator said they are working on it.
Top